Cisco Systems RSP8 Router# copy tftp slot slot-number, Router# copy tftp slaveslot slot-number

Enabling High Availability Features

To copy a Cisco IOS software image from a TFTP server to a Flash memory card or Flash Disk on the active RSP, use the following commands beginning in privileged EXEC configuration mode:

	Command	Purpose
Step 1
	Router# copy tftp slotslot-number:	Uses TFTP to copy a high availability Cisco IOS
		image onto the Flash memory card or Flash Disk of
		the active RSP.1
		• slotslot-number—Specifies the Flash memory
		card or Flash Disk of the active RSP.
	Address or name of remote host []? ip-address	The router prompts you for the IP address of the
		TFTP server.
		• ip-address—Specifies the IP address of the TFTP
		server that contains the new image.
	Name of file to copy []? imagename<Return>	The router prompts you for the name of the image file
	writing filename!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!	you are copying to the Flash memory card or Flash
		Disk.
		• imagename—Indicates the name of the image to
		be loaded onto the Flash memory card or Flash
		Disk.
	Destination filename? [imagename1] <Return>	The router prompts you to enter the name under
	Accessing tftp://host ip-address/file 'imagename' on
		which you want the file to appear at the destination.
	ip-address.. found !
	11188128 bytes copied in 2280.664 secs (4906	• imagename1—Indicates the name of the image
	bytes/sec)	as it appears at the destination.
Step 2
	Router# copy tftp slaveslotslot-number:	Uses TFTP to copy a high availability Cisco IOS
		image onto the Flash memory card or Flash Disk of
		the standby RSP.
		• slaveslotslot-number—Specifies the Flash
	Address or name of remote host []? ip-address	memory card or Flash Disk of the standby RSP.
		The router prompts you for the IP address of the
		TFTP server.
	Name of file to copy []? imagename<Return>	• ip-address—Specifies the IP address of the TFTP
	writing	server that contains the new image.
	filename!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
		The router prompts you for the name of the image file
		you are copying to the Flash memory card or Flash
	Destination filename? [imagename1] <Return>	Disk.
	Accessing file 'imagename' on ip-address.. found !	• imagename—Indicates the name of the image to
	903500 bytes available for writing without erasure.	be loaded onto the Flash memory card or Flash
	Loading imagename from ip-address (via Ethernet1/0):
		Disk.
	!
	[OK - 3320245/4194176 bytes]	The router prompts you to enter the name under
		which you want the file to appear at the destination.
		• imagename1—Indicates the name of the image
		as it appears at the destination.

1.Before you copy a file to Flash memory, be sure there is ample space available in Flash memory. Compare the size of the file you are copying to the amount of available Flash memory shown. If the space available is less than the space required by the file you will copy, the copy process will continue, but the entire file will not be copied into Flash memory.

Route Switch Processor (RSP8) Installation and Configuration Guide

OL-4920-02 45