Billion Electric Company 7100S user manual 3.2 LAN, Device IP Address

Page 31

Chapter 3 Configuration

Automatic Reconnect: Check to enable this device to automatically re-establish the PPPoE session when disconnected by ISP.

3.4.3.2 LAN

This screen contains settings for LAN interface attached to the LAN port.

Device IP Address

IP Address: Default at 192.168.1.254.

This is the device IP address in LAN site. If you plan to change it to another IP address to a different range of IP subnet. Please make sure your PC is also located at the same IP subnet. Otherwise, you may not be able to access the router.

Subnet Mask: Default at 255.255.255.0.

DHCP Server

DHCP Server: Check DHCP Server to enable the router to distribute IP Addresses, subnet mask and DNS setting to computers. Hence, the following fields will be activated. If you do not check this selection, remember to specify a static IP address, subnet Mask, and DNS setting for each of your local computers. Be careful not to assign the same IP address to different computers.

DHCP address pool selection: Auto or User Defined. If select the AUTO, router will assign an IP address back to PC’s IP request. If User Defined, please specify the IP pool range.

User Defined Start Address: Enter the start address of this local IP network address pool. The pool is a piece of continuous IP address segment. The default value is 192.168.1.100.

User Defined End Address: Enter the last address of this local IP network address pool that you want the DHCP server to assign IP addresses to. The default value is 192.168.1.199.

27

Image 31

Contents Bipac 7100S Page Table of Contents Appendix An Overview of Bipac 7100S Chapter IntroductionBipac 7100S Features Package ContentsIntroduction Bipac 7100S ApplicationFront LEDs Lit green when power adapter is connectedLit green when the LAN link is connected Flashes green when collision happensThrough Ethernet Port Line RJ-11 connector Reset LAN RJ-45 connectorRear Ports CablingBillion Bipac 7100S Adsl Modem/Router Configuring PC in Windows XP Before ConfigurationBillion Bipac 7100S Adsl Modem/Router Configuration Configuring PC in WindowsBillion Bipac 7100S Adsl Modem/Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings IP addresses for Information from ISPLAN Port WAN Port IP address Dhcp server functionConfiguring with Web Browser Quick Start StatusAdsl Status WAN Status Status Adsl StatusAdsl Status ATM Status Status LAN StatusLAN Status TCP Status Status- PPP StatusRouting Table Status- Learned MAC TableSecurity Logs System LogSelect Adapter 3.1 WANBillion Bipac 7100S Adsl Modem/Router ATM Static IP Settings Service Category Select UBR or CBR Dhcp ClientMAC Spoofing Device IP Address 3.2 LANSystem PasswordTime Zone Factory Setting UpgradeRestart Packet Filter FirewallConfiguration Intrusion Detection Bridge FilteringSnork Attack UDP port loop-back TCP Null scan Block WAN RequestURL Blocking VPN Virtual Private Networks Billion Bipac 7100S Adsl Modem/Router Virtual Server Adsl Advanced3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Snmp Static Routing Diagnostic Test Misc ConfigurationTesting Adsl Synchronization Testing Ethernet LAN connectionTest ATM OAM Segment Loop Back Test Ethernet connect to ATM Test ATM OAM End-to-End Loop BackTest IP connect to PPP Save Config Problems Connecting to a Remote Node or ISP Problems Starting Up the Adsl Router Corrective ActionProblems with the WAN Interface Corrective Action Problems with the LAN Interface Corrective ActionContact Billion Appendix