Billion Electric Company 7100S user manual Rear Ports, Cabling, Through Ethernet Port

Page 9

Chapter 2 Using the ADSL Modem/Router

2.3 The Rear Ports

LINE (RJ-11 connector)

Reset

LAN (RJ-45 connector)

Connect the supplied RJ-11 cable to this port when connecting to the ADSL

Press it to restore the factory default setting back

Connect the supplied crossover cable to this port when connecting to a NIC (Network Interface card) in PC.

Connect an UTP Ethernet cable to this port when connecting to a LAN such as an office or home network.

Power	Connect the supplied power adapter to
(jack)	this jack.

Power Switch

A Power ON/OFF switch

2.4 Cabling

Through Ethernet Port

The product’s LAN port is wired just like a Network Adapter’s port. From the product directly to a PC, the cable should be an Ethernet crossover cable. From the product to a hub or switch, the cable should be an Ethernet straight through cable to a normal hub/switch port, or an Ethernet crossover cable to an uplink port.

The most common problem associated with Ethernet is bad cabling or ADSL line. Make sure that all connected devices are turned on. On the front of the product is a bank of LEDs. As a first check, please verify that the PWR, LAN LNK and ADSL SYN LEDs are lit. If they are not, verify that you are using the proper cables.

5

Image 9

Contents Bipac 7100S Page Table of Contents Appendix An Overview of Bipac 7100S Chapter IntroductionBipac 7100S Features Package ContentsIntroduction Bipac 7100S ApplicationLit green when the LAN link is connected Lit green when power adapter is connectedFlashes green when collision happens Front LEDsRear Ports Line RJ-11 connector Reset LAN RJ-45 connectorCabling Through Ethernet PortBillion Bipac 7100S Adsl Modem/Router Configuring PC in Windows XP Before ConfigurationBillion Bipac 7100S Adsl Modem/Router Configuration Configuring PC in WindowsBillion Bipac 7100S Adsl Modem/Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings LAN Port WAN Port IP address Information from ISPDhcp server function IP addresses forConfiguring with Web Browser Quick Start StatusAdsl Status WAN Status Status Adsl StatusAdsl Status ATM Status Status LAN StatusLAN Status TCP Status Status- PPP StatusRouting Table Status- Learned MAC TableSecurity Logs System LogSelect Adapter 3.1 WANBillion Bipac 7100S Adsl Modem/Router ATM Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing Device IP Address 3.2 LANSystem PasswordTime Zone Factory Setting UpgradeRestart Packet Filter FirewallConfiguration Intrusion Detection Bridge FilteringSnork Attack UDP port loop-back TCP Null scan Block WAN RequestURL Blocking VPN Virtual Private Networks Billion Bipac 7100S Adsl Modem/Router Virtual Server Advanced Adsl3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Snmp Static Routing Diagnostic Test Misc ConfigurationTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM Segment Loop Back Test ATM OAM End-to-End Loop Back Test Ethernet connect to ATMTest IP connect to PPP Save Config Problems with the WAN Interface Corrective Action Problems Starting Up the Adsl Router Corrective ActionProblems with the LAN Interface Corrective Action Problems Connecting to a Remote Node or ISPContact Billion Appendix