Billion Electric Company 7100S user manual Misc Configuration, Diagnostic Test

Page 51

Chapter 3 Configuration

3.4.3.7.8 MISC Configuration

HTTP server access: Default at Restricted.

HTTP server port: Default at 80.

FTP server: Default at Enabled.

TFTP server: Default at Disabled.

DMZ: Regarding the DMZ Host, it is a local computer exposed to the Internet. Therefore, an incoming packet will be checked by NAT algorithms in the ADSL Router, then passed to the DMZ host when the packet is not sent by hacker or not limited by the virtual server list.

DMZ HOST IP: Enter the IP address of the DMZ host.

DHCP Relay: Default at DHCP Server.

DHCP Target IP: Default is 0.0.0.0

IGMP Proxy: Default at Disabled.

PPP Half Bridge: Default at Disabled.

PPPreconnect on WAN access: Default at Disabled. Select Enabled if you want to automatically re- establish the PPPoE/PPPoA session when disconnected by ISP.

3.4.3.7.9Diagnostic Test

As soon as you enter the test program, all tests will run automatically to diagnose the connection status of the device.

47

Image 51

Contents Bipac 7100S Page Table of Contents Appendix An Overview of Bipac 7100S Chapter IntroductionBipac 7100S Features Package ContentsIntroduction Bipac 7100S ApplicationFront LEDs Lit green when power adapter is connectedLit green when the LAN link is connected Flashes green when collision happensThrough Ethernet Port Line RJ-11 connector Reset LAN RJ-45 connectorRear Ports CablingBillion Bipac 7100S Adsl Modem/Router Configuring PC in Windows XP Before ConfigurationBillion Bipac 7100S Adsl Modem/Router Configuration Configuring PC in WindowsBillion Bipac 7100S Adsl Modem/Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings IP addresses for Information from ISPLAN Port WAN Port IP address Dhcp server functionConfiguring with Web Browser Quick Start StatusAdsl Status WAN Status Status Adsl StatusAdsl Status ATM Status Status LAN StatusLAN Status TCP Status Status- PPP StatusRouting Table Status- Learned MAC TableSecurity Logs System LogSelect Adapter 3.1 WANBillion Bipac 7100S Adsl Modem/Router ATM Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing Device IP Address 3.2 LANSystem PasswordTime Zone Factory Setting UpgradeRestart Packet Filter FirewallConfiguration Intrusion Detection Bridge FilteringSnork Attack UDP port loop-back TCP Null scan Block WAN RequestURL Blocking VPN Virtual Private Networks Billion Bipac 7100S Adsl Modem/Router Virtual Server Advanced Adsl3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Snmp Static Routing Diagnostic Test Misc ConfigurationTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM Segment Loop Back Test ATM OAM End-to-End Loop Back Test Ethernet connect to ATMTest IP connect to PPP Save Config Problems Connecting to a Remote Node or ISP Problems Starting Up the Adsl Router Corrective ActionProblems with the WAN Interface Corrective Action Problems with the LAN Interface Corrective ActionContact Billion Appendix