Chapter 2 Installation Overview
Before Beginning the Installation
Note The external antenna access point/bridge configuration does not ship with an external antenna. An external antenna must be purchased.
The optional roof mount kit contains these items:
•One
•Two
•
•Two tower clamps
•Four bolts and washers for securing the access point/bridge bracket to the mast bracket
•Four bolts for securing the access point/bridge bracket to the unit
•Grounding block and mounting screws
•Ground lug for the access point/bridge, two hex nuts, and two washers
•Weatherproofing kit (consisting of Coax Seal and electrical joint compound)
The optional wall mount kit (for indoor use) contains these items:
•Wall mount bracket with 4 mounting bolts and washers
•Two
•Power injector (LR2T) unit
Before Beginning the Installation
Before you begin the installation process, please carefully review the following list of figures to become familiar with the system components, connectors, indicators, cables, system interconnection, and grounding:
•Installation diagram (Figure
•Access point/bridge layout (Figure
•Power injector layout (Figure
•Power module (Figure
•Grounding block (Figure
Note To meet regulatory restrictions, the external antenna access point/bridge unit and the external antenna must be professionally installed. The network administration or other IT professional responsible for installing and configuring the unit is a suitable professional installer. Following installation, access to the unit should be
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
|
| ||
|
|