Chapter 4 Troubleshooting Autonomous Access Points and Bridges
Obtaining the Autonomous Access Point/Bridge Image File
Connecting to the Console Serial Port
If you need to configure the access point locally (without connecting to a wired LAN), you can connect a PC to the power injector console serial port. Follow these steps to open the CLI by connecting to the console serial port:
Step 1 Connect a
Figure 4-3 Console Serial Port Connector
AIRONETINJECTOR
CISCOPOWER
117188
1
1
Console serial port connector
Note The Cisco part number for the
Step 2 Set up a terminal emulator to communicate with the access point. Use the following settings for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
Step 3 When the terminal emulator is activated, press Enter.
Step 4 At the prompts, enter the administrator username and password. The default username is Cisco and the default password is Cisco. The username and password are case sensitive.
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
|
| |
|