Chapter 5 Troubleshooting Lightweight Access Points
Manually Configuring Controller Information Using the Access Point CLI
Manually Configuring Controller Information Using the Access Point CLI
In a new installation, when your access point is unable to reach a DHCP server, you can manually configure needed controller information using the lightweight access point CLI.
Note The CLI commands in this section can be used only on a lightweight access point that is not associated to a controller.
The static information configured with the CLI commands are used by the lightweight access point to connect with a controller. After connecting with the controller, the controller reconfigures the access point with new controller settings, but the static IP addresses for the access point and the default gateway are not changed.
Connecting to the Console Serial Port
If you need to configure the access point locally (without connecting to a wired LAN), you can connect a PC to the power injector console serial port using a
Step 1 Connect a
Figure 5-3 Console Serial Port Connector
AIRONETINJECTOR
CISCOPOWER
117188
1
1
Console serial port connector (RJ-45 connector)
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
|
| |
|