XP SBC HC 410/00
Controls | Installation |
|
|
English
Headphone (figure 2)
9Power indication – lights up when in use. When batteries are low, the power indicator flashes, and you should recharge the headphone for about 16 hours before the next use.
10Power On/Off – push the button to switch the headphone on/off.
11Recharging contacts – align headphone to the transmitter, green recharging LED on the transmitter’s front must switch on, indicating that the headphone is being recharged.
12Volume – adjust volume to your desired listening level.
13Tuning – Turn the tuning knob until the signal is at its clearest and the tuning indicator will light up.
14Tuning indicator – lights up when receiving optimal transmission.
Environmental Information
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC CS030/05)
1Make sure the adapter’s rated voltage corresponds to the mains socket voltage.
2Connect the DC connector of the AC/DC adapter to the 12 Volt DC power input connector located at the rear of the transmitter.
3Connect the 12 Volt/200 mA AC/DC adapter to the mains socket.
–Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time.
Headphone power supply
IMPORTANT
Use only rechargeable LR03/AAA NiMH batteries (preferably Philips).
Do not use NiCd batteries or alkaline batteries as these may damage your FM wireless system!
1Check if the power button of the FM headphone is in the on position.
2When the red power indicator on the FM headphone starts flashing, it indicates that the batteries are running low.
3To recharge the headphone’s
All redundant packing material has been omitted.We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
6