Cabletron Systems F3 user manual Connecting the AUI Cable

Page 23

CONNECTING THE FOT-F3 TO THE NETWORK

SQE SWITCH

SQE SQE

Enabled Disabled

	SQE
P	S	X	R	C	L
W	Q	M	C	L	N
R	E	T	V	N	K
					0461-06

Figure 3-1 SQE Switch

3.2.2Connecting the AUI Cable

To connect your Ethernet device to the FOT-F3, attach an AUI cable as follows. See Figure 3-2.

1.Attach an AUI cable to the device to which the FOT-F3 will be connected.

FOT-F3 USER’S MANUAL

3-3

Image 23

Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Page FOT-F3 USER’S Manual DOC Notice FCC NoticeVcci Notice Industrial Environment Declaration of ConformityContents Testing and Troubleshooting Chapter Introduction Using this ManualOverview of the FOT-F3 ConventionsFOT-F3 ConnectionsDistance and Cable Type Signal Quality Error SQE TestLanview LEDs Lanview LEDsRCV Receive PWR PowerSQE Signal Quality Error Test Function XMT TransmitApplication FOT-F3 Setup, ExampleMmac Your email address Getting HelpRelated Manuals Fiber Optic Requirements Chapter Installation RequirementsNetwork Design Guidelines AUI Cable Requirements Installation RequirementsUnpacking the FOT-F3 Chapter InstallationSetting the SQE Switch Connecting the FOT-F3 to the NetworkConnecting the AUI Cable AUI Connection Connecting the Fiber Optic Cable Installation ST Connectors Surface Mounting the FOT-F3 Cable Strain Relief for Surface Mounted FOT-F3 Cable Support InstallationSurface Mounting the FOT-F3 Cable Strain Relief for Non-Mounted FOT-F3Cable Support Installation Installation Testing the Fiber Optic Link Segment Chapter Testing and TroubleshootingInstallation CHECK-OUT Testing and Troubleshooting Installation Checkout Testing the FOT-F3 Fiber Optic TransceiverUsing Lanview Collision CLN LED Lanview LEDs Optical Link OK LNK LEDTransmit XMT LED Signal Quality Error SQE Test Function LEDReceive RCV LED Power PWR LED Testing and Troubleshooting Fiber Optic Interface Appendix a SpecificationsAppendix a Specifications Power Supply AUI ConnectorPhysical SafetyEnvironmental Agency Approvals