Cabletron Systems user manual FOT-F3 USER’S Manual

Page 3

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright 1996 by: Cabletron Systems, Inc.,

P.O. Box 5005, Rochester, NH 03866-5005

All Rights Reserved

Printed in the United States of America

Part Number: 9030461-01 July 1996

LANVIEW is a registered trademark of Cabletron Systems, Inc.

LAN-MD,FOT-F3,FOMIM-32/36/38,MMAC, NBR-220, and IRM are trademarks of Cabletron Systems, Inc.

Velcro is a registered trademark of Velcro Industries, B.V.

Printed on

Recycled Paper

FOT-F3 USER’S MANUAL

i

Image 3
Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Page FOT-F3 USER’S Manual DOC Notice FCC NoticeVcci Notice Industrial Environment Declaration of ConformityContents Testing and Troubleshooting Chapter Introduction Using this ManualOverview of the FOT-F3 ConventionsFOT-F3 ConnectionsDistance and Cable Type Signal Quality Error SQE TestLanview LEDs Lanview LEDsRCV Receive PWR PowerSQE Signal Quality Error Test Function XMT TransmitApplication FOT-F3 Setup, ExampleMmac Your email address Getting HelpRelated Manuals Chapter Installation Requirements Network Design GuidelinesFiber Optic Requirements AUI Cable Requirements Installation RequirementsUnpacking the FOT-F3 Chapter InstallationSetting the SQE Switch Connecting the FOT-F3 to the NetworkConnecting the AUI Cable AUI Connection Connecting the Fiber Optic Cable Installation ST Connectors Surface Mounting the FOT-F3 Cable Strain Relief for Surface Mounted FOT-F3 Cable Support InstallationSurface Mounting the FOT-F3 Cable Strain Relief for Non-Mounted FOT-F3Cable Support Installation Installation Chapter Testing and Troubleshooting Installation CHECK-OUTTesting the Fiber Optic Link Segment Testing and Troubleshooting Installation Checkout Testing the FOT-F3 Fiber Optic TransceiverUsing Lanview Collision CLN LED Lanview LEDs Optical Link OK LNK LEDSignal Quality Error SQE Test Function LED Receive RCV LEDTransmit XMT LED Power PWR LED Testing and Troubleshooting Fiber Optic Interface Appendix a SpecificationsAppendix a Specifications Power Supply AUI ConnectorPhysical SafetyEnvironmental Agency Approvals