Cabletron Systems F3 user manual FCC Notice, DOC Notice

Page 4

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

Warning: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

FOT-F3 USER’S MANUAL

Image 4
Contents FOT-F3 Fiber Optic Transceiver USER’S Manual Page FOT-F3 USER’S Manual FCC Notice DOC NoticeVcci Notice Declaration of Conformity Industrial EnvironmentContents Testing and Troubleshooting Using this Manual Chapter IntroductionConventions Overview of the FOT-F3Connections FOT-F3Signal Quality Error SQE Test Distance and Cable TypeLanview LEDs Lanview LEDsPWR Power SQE Signal Quality Error Test FunctionXMT Transmit RCV ReceiveFOT-F3 Setup, Example ApplicationMmac Getting Help Your email addressRelated Manuals Network Design Guidelines Chapter Installation RequirementsFiber Optic Requirements Installation Requirements AUI Cable RequirementsChapter Installation Unpacking the FOT-F3Connecting the FOT-F3 to the Network Setting the SQE SwitchConnecting the AUI Cable AUI Connection Connecting the Fiber Optic Cable Installation ST Connectors Surface Mounting the FOT-F3 Cable Support Installation Cable Strain Relief for Surface Mounted FOT-F3Cable Strain Relief for Non-Mounted FOT-F3 Surface Mounting the FOT-F3Cable Support Installation Installation Installation CHECK-OUT Chapter Testing and TroubleshootingTesting the Fiber Optic Link Segment Testing and Troubleshooting Testing the FOT-F3 Fiber Optic Transceiver Installation CheckoutUsing Lanview Lanview LEDs Optical Link OK LNK LED Collision CLN LEDReceive RCV LED Signal Quality Error SQE Test Function LEDTransmit XMT LED Power PWR LED Testing and Troubleshooting Appendix a Specifications Fiber Optic InterfaceAppendix a Specifications AUI Connector Power SupplySafety EnvironmentalAgency Approvals Physical