Cabletron Systems SEHI100TX manual Editing the Community Name Field

The Community Name Table Screen

ACCESS

Indicates the access status accorded each community name. The following conditions are possible:

Basic-Read	This allows Read-Only access to Local
	Management, but excludes read privileges to
	the Component Trap screen.
Read-Only	This allows Read-Only access to Local
	Management, but excludes access to security
	protected fields of the upper levels of
	authorization (Read-Write or Super-User).
Read-Write	This allows the user to read and write to Local
	Management fields, excluding IP Address,
	Subnet Mask, and Community Names.
Super-User	This access privilege gives the user read and
	write access to Local Management. Super-User
	allows read and write access to all modifiable
	parameters including: Community Names, IP
	Addresses, Traps, and SNMP Objects.

7.5.1Editing the Community Name Field

The password used to access Local Management at the Password screen must have Super-User privileges for the edits to take effect. If a password is entered with Basic-Read, Read-Only, or Read-Write privileges, Local Management displays the message “AUTHORIZATION PROHIBITS ACCESS”, and does not include editing capabilities.

Use the following steps to edit the Community Name field:

1.Use the arrow keys to highlight the Community Name field adjacent to the desired access level.

2.Enter the community name (maximum of 32 characters) into the field.

3.Press ENTER.

4.Repeat steps 1-3 for editing any of the other community names.

5.Use the arrow keys to highlight the SAVE command at the bottom of the screen, then press ENTER or F6. The “SAVED OK” message appears indicating that the edits have been saved to memory.

SEHI100TX User’s Guide 7-9