Cabletron Systems 9A426-02 manual Unpacking an Apim

Page 17

Preparing and Installing the 9A426-02 Module

Unpacking an APIM

1.Remove the APIM from the shipping box. (Save the box and packing materials in the event the APIM must be reshipped.)

2.Remove the APIM from the non-conductive bag.

3.Examine the APIM and check for damage. If damage exists, DO NOT proceed; contact Cabletron Systems Technical Support. Otherwise, place the APIM back into the non-conductive bag, set the APIM aside, and proceed.

80 pin (female) connector

Figure 2-3. An APIM-21

Removing the 9A426-02 Module’s ATM-Port Retaining Plate

WARNING

To install an APIM properly in the 9A426-02 Module, you MUST remove the module’s ATM-Port Retaining Plate. Failure to do so can damage the module and the APIM.

1.Place the module (component side up) on a non-conductive, ﬂat surface. Position the module so that the module’s front (faceplate) is to the left and the module’s back (backplane connectors) is to the right. See Figure 2-4.

2.Locate the module’s ATM-Port Retaining Plates. Each plate is secured by two screws and is located on the right side panel of the module’s faceplate. See Figure 2-4.

2-5

Image 17

Contents SmartSwitch 9A426-02 User’s Guide Page Page DOC Notice FCC NoticeVcci Notice Declaration of Conformity Page Contents CPU Chapter Lanview LEDs SpeciﬁcationsIntroduction Ietf Fddi MIB FeaturesLanview LEDs Getting Help Related ManualsModule’s Physical Layout Unpacking the Module9A426-02 Module’s two major circuit boards User-Accessible Components on the Module’s MotherboardLook-Up Engines APIMs Installing an Apim in the 9A426-02 ModuleSram SIMMs Removing the 9A426-02 Module’s ATM-Port Retaining Plate Unpacking an ApimATM-Port Retaining Plate Removing the ATM-Port Retaining Plate Inserting an Apim into the 9A426-02 ModuleAttaching an Apim to a 9A426-02 Module Attaching the 9A426-02 Module’s ATM-Port Retaining PlateUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module 12. The Reset Switch Reset SwitchOperation Front Panel Backplane SMB-1 Bus LAN EmulationSystem Management Buses DC/DC Converter System Diagnostic ControllerINB Network Interface Block SMB-10 BusSecureFast Virtual Networking Fddi Network Interface BlockATM Network Interface Block I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Technical Speciﬁcations PowerMemory Address Table SizeStandards SafetyService Weight DimensionsPhysical EnvironmentSpeciﬁcations