Cabletron Systems 9A426-02 manual Safety, Service, Standards

Page 44

Speciﬁcations

Standards

ATM Forum UNI v3.0/3.1

ITU I.361 ATM Layer

Q.2931

LAN Emulation v1.0

Safety

!

CAUTION

It is the responsibility of the person who sells the system to which the module will be a part to ensure that the total system meets allowed limits of conducted and radiated emissions.

This equipment meets the safety requirements of:

UL 1950

CSA C22.2 No. 950

EN 60950

IEC 950

The EMI Requirements of:

•FCC Part 15 Class A

•EN 55022 Class A

•VCCI Class I

The EMC requirements of:

•EN 50082-1

•IEC 801-2 ESD

•IEC 801-3 Radiated susceptibility

•IEC 801-4 EFT

Service

MTBF (MHBK-217E)	>200,000 hrs.
MTTR	<0.5 hr.

5-2

Image 44

Contents SmartSwitch 9A426-02 User’s Guide Page Page DOC Notice FCC NoticeVcci Notice Declaration of Conformity Page Contents Chapter Lanview LEDs Speciﬁcations CPUIntroduction Features Ietf Fddi MIBLanview LEDs Related Manuals Getting HelpUnpacking the Module Module’s Physical LayoutUser-Accessible Components on the Module’s Motherboard 9A426-02 Module’s two major circuit boardsLook-Up Engines APIMs Installing an Apim in the 9A426-02 ModuleSram SIMMs Unpacking an Apim Removing the 9A426-02 Module’s ATM-Port Retaining PlateATM-Port Retaining Plate Inserting an Apim into the 9A426-02 Module Removing the ATM-Port Retaining PlateAttaching the 9A426-02 Module’s ATM-Port Retaining Plate Attaching an Apim to a 9A426-02 ModuleUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module Reset Switch 12. The Reset SwitchOperation Front Panel Backplane SMB-1 Bus LAN EmulationSystem Management Buses System Diagnostic Controller DC/DC ConverterINB Network Interface Block SMB-10 BusSecureFast Virtual Networking Fddi Network Interface BlockATM Network Interface Block I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Power Technical SpeciﬁcationsMemory Address Table SizeStandards SafetyService Dimensions WeightPhysical EnvironmentSpeciﬁcations