Cabletron Systems 9A426-02 manual FCC Notice, Vcci Notice, DOC Notice

Page 4

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment (VCCI) aimed at preventing radio interference in commercial and/or industrial areas.

Consequently, when used in a residential area or in an adjacent area thereto, radio interference may be caused to radios and TV receivers, etc.

Read the instructions for correct handling.

DOC Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Page 3 Page 5
Image 4
Page 3 Page 5
Contents SmartSwitch 9A426-02 User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Declaration of Conformity Page Contents Chapter Lanview LEDs Specifications CPUIntroduction Features Ietf Fddi MIBLanview LEDs Related Manuals Getting HelpUnpacking the Module Module’s Physical LayoutUser-Accessible Components on the Module’s Motherboard 9A426-02 Module’s two major circuit boardsLook-Up Engines Sram SIMMs Installing an Apim in the 9A426-02 ModuleAPIMs Unpacking an Apim Removing the 9A426-02 Module’s ATM-Port Retaining PlateATM-Port Retaining Plate Inserting an Apim into the 9A426-02 Module Removing the ATM-Port Retaining PlateAttaching the 9A426-02 Module’s ATM-Port Retaining Plate Attaching an Apim to a 9A426-02 ModuleUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module Reset Switch 12. The Reset SwitchOperation Front Panel Backplane System Management Buses LAN EmulationSMB-1 Bus System Diagnostic Controller DC/DC ConverterINB Network Interface Block SMB-10 BusATM Network Interface Block Fddi Network Interface BlockSecureFast Virtual Networking I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Power Technical SpecificationsMemory Address Table SizeService SafetyStandards Dimensions WeightPhysical EnvironmentSpecifications
Top Page Image Contents