Cabletron Systems 9A426-02 manual Status of the ATM Transmit LED is listed in Table

Page 40

LANVIEW LEDs

The status of the ATM Transmit LED is listed in Table 4-7.

Table 4-7. ATM Transmit LEDs

LED Color	State

Green (Flashing)	Activity

Red	Failure

Off	No Activity

The following section lists the conditions of the APIM status (STS) and link (LNK) LANVIEW LED’s.

An example showing the location of LANVIEW LEDs on an APIM is presented in Figure 4-2. For further information about a particular APIM, refer to that speciﬁc APIM’s documentation.

1 2 3 4 5 6 7 8

STS

LNK

Figure 4-2. The LANVIEW LEDs of an APIM-22

The status of the APIM Status (STS) LED is listed in Table 4-8.

	Table 4-8. APIM Status (STS) LED

LED Color		State

Green		Active

Amber		Reset

Red		Failure

4-4

Image 40

Contents SmartSwitch 9A426-02 User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Declaration of Conformity Page Contents Chapter Lanview LEDs Speciﬁcations CPUIntroduction Features Ietf Fddi MIBLanview LEDs Related Manuals Getting HelpUnpacking the Module Module’s Physical LayoutUser-Accessible Components on the Module’s Motherboard 9A426-02 Module’s two major circuit boardsLook-Up Engines Sram SIMMs Installing an Apim in the 9A426-02 ModuleAPIMs Unpacking an Apim Removing the 9A426-02 Module’s ATM-Port Retaining PlateATM-Port Retaining Plate Inserting an Apim into the 9A426-02 Module Removing the ATM-Port Retaining PlateAttaching the 9A426-02 Module’s ATM-Port Retaining Plate Attaching an Apim to a 9A426-02 ModuleUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module Reset Switch 12. The Reset SwitchOperation Front Panel Backplane System Management Buses LAN EmulationSMB-1 Bus System Diagnostic Controller DC/DC ConverterINB Network Interface Block SMB-10 BusATM Network Interface Block Fddi Network Interface BlockSecureFast Virtual Networking I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Power Technical SpeciﬁcationsMemory Address Table SizeService SafetyStandards Dimensions WeightPhysical EnvironmentSpeciﬁcations