Cabletron Systems 9A426-02 manual Contents

Page 7

Contents

Chapter 1	Introduction
	Features	1-2
	Related Manuals	1-4
	Getting Help	1-4

Chapter 2	Preparing and Installing
	the 9A426-02 Module
	Unpacking the Module	2-1
	The Module’s Physical Layout	2-1
	User-Accessible Components on the Module’s Motherboard	2-2
	Look-Up Engines	2-3
	SRAM SIMMs	2-4
	APIMs	2-4
	Installing an APIM in the 9A426-02 Module	2-4
	Unpacking an APIM	2-5
	Removing the 9A426-02 Module’s ATM-Port Retaining Plate	2-5
	Inserting an APIM into the 9A426-02 Module	2-7
	Attaching the 9A426-02 Module’s ATM-Port Retaining Plate	2-8
	User-Accessible Components on the Module’s Daughterboard	2-9
	DIP Switch	2-10
	Removing the Daughterboard from the Motherboard	2-12
	Installing the Module into the SmartSwitch 9000 Chassis	2-15
	The Reset Switch	2-18

Chapter 3	Operation
	LAN Emulation	3-3
	System Management Buses	3-3
	SMB-1 Bus	3-3
	SMB-10 Bus	3-4
	System Diagnostic Controller	3-4
	DC/DC Converter	3-4
	INB Network Interface Block	3-4
	FDDI Network Interface Block	3-5
	ATM Network Interface Block	3-5
	SecureFast Virtual Networking	3-5
	i960 Core	3-6

v

Image 7

Contents SmartSwitch 9A426-02 User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Declaration of Conformity Page Contents CPU Chapter Lanview LEDs SpeciﬁcationsIntroduction Ietf Fddi MIB FeaturesLanview LEDs Getting Help Related ManualsModule’s Physical Layout Unpacking the Module9A426-02 Module’s two major circuit boards User-Accessible Components on the Module’s MotherboardLook-Up Engines Sram SIMMs Installing an Apim in the 9A426-02 ModuleAPIMs Removing the 9A426-02 Module’s ATM-Port Retaining Plate Unpacking an ApimATM-Port Retaining Plate Removing the ATM-Port Retaining Plate Inserting an Apim into the 9A426-02 ModuleAttaching an Apim to a 9A426-02 Module Attaching the 9A426-02 Module’s ATM-Port Retaining PlateUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module 12. The Reset Switch Reset SwitchOperation Front Panel Backplane System Management Buses LAN EmulationSMB-1 Bus SMB-10 Bus System Diagnostic ControllerDC/DC Converter INB Network Interface BlockATM Network Interface Block Fddi Network Interface BlockSecureFast Virtual Networking I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Address Table Size PowerTechnical Speciﬁcations MemoryService SafetyStandards Environment DimensionsWeight PhysicalSpeciﬁcations