Cabletron Systems manual Attaching the 9A426-02 Module’s ATM-Port Retaining Plate

Page 20

Preparing and Installing the 9A426-02 Module

Figure 2-6. Attaching an APIM to a 9A426-02 Module

7.Press down gently on the APIM to lock its female connector into the 9A426-02 Module’s male connector.

8.Secure the APIM to the module: Use a Phillips-head screwdriver to attach four round-head screws to the four standoffs on the 9A426-02 Module.

9.Attach the 9A426-02 Module’s ATM-Port Retaining Plate (see next page).

NOTE

Steps 1 through 9 explain how to insert one APIM in the 9A426-02 Module. To insert a second APIM, repeat the same steps.

Attaching the 9A426-02 Module’s ATM-Port Retaining Plate

1.Place the module (component side up) on a non-conductive, ﬂat surface. Position the module so that the module’s front (faceplate) is facing you.

2.Locate the area where the ATM-Port Retaining Plate attaches to the faceplate.

3.Place the ATM-Port Retaining Plate on the module (align the retaining plate’s securing holes with the module’s securing holes). Make sure the Retaining Plate’s faceplate (its smaller side) is ﬂush with the module’s faceplate (see Figure 2-7).

4.Secure the retaining plate to the module: Use a Phillips-head screwdriver to attach two ﬂathead mounting screws to the module.

2-8

Image 20

Contents SmartSwitch 9A426-02 User’s Guide Page Page DOC Notice FCC NoticeVcci Notice Declaration of Conformity Page Contents Chapter Lanview LEDs Speciﬁcations CPUIntroduction Features Ietf Fddi MIBLanview LEDs Related Manuals Getting HelpUnpacking the Module Module’s Physical LayoutUser-Accessible Components on the Module’s Motherboard 9A426-02 Module’s two major circuit boardsLook-Up Engines APIMs Installing an Apim in the 9A426-02 ModuleSram SIMMs Unpacking an Apim Removing the 9A426-02 Module’s ATM-Port Retaining PlateATM-Port Retaining Plate Inserting an Apim into the 9A426-02 Module Removing the ATM-Port Retaining PlateAttaching the 9A426-02 Module’s ATM-Port Retaining Plate Attaching an Apim to a 9A426-02 ModuleUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module Reset Switch 12. The Reset SwitchOperation Front Panel Backplane SMB-1 Bus LAN EmulationSystem Management Buses System Diagnostic Controller DC/DC ConverterINB Network Interface Block SMB-10 BusSecureFast Virtual Networking Fddi Network Interface BlockATM Network Interface Block I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Power Technical SpeciﬁcationsMemory Address Table SizeStandards SafetyService Dimensions WeightPhysical EnvironmentSpeciﬁcations