Cabletron Systems manual Preparing and Installing the 9A426-02 Module

Page 28

Preparing and Installing the 9A426-02 Module

2.Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000 chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding receptacle in the lower right corner of the SmartSwitch 9000 Chassis shown in Figure 2-11.

3.Grasp the module and slide it into the slot.

Make sure that the module’s circuit card is between the card guides, as shown in Figure 2-11. Check both the upper and lower tracks of the card. Take care that the module slides in straight and engages the backplane connectors properly.

4.Lock down the top and bottom plastic tabs, as shown in Figure 2-11.

2-16

Image 28

Contents SmartSwitch 9A426-02 User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Declaration of Conformity Page Contents Chapter Lanview LEDs Speciﬁcations CPUIntroduction Features Ietf Fddi MIBLanview LEDs Related Manuals Getting HelpUnpacking the Module Module’s Physical LayoutUser-Accessible Components on the Module’s Motherboard 9A426-02 Module’s two major circuit boardsLook-Up Engines Sram SIMMs Installing an Apim in the 9A426-02 ModuleAPIMs Unpacking an Apim Removing the 9A426-02 Module’s ATM-Port Retaining PlateATM-Port Retaining Plate Inserting an Apim into the 9A426-02 Module Removing the ATM-Port Retaining PlateAttaching the 9A426-02 Module’s ATM-Port Retaining Plate Attaching an Apim to a 9A426-02 ModuleUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module Reset Switch 12. The Reset SwitchOperation Front Panel Backplane System Management Buses LAN EmulationSMB-1 Bus System Diagnostic Controller DC/DC ConverterINB Network Interface Block SMB-10 BusATM Network Interface Block Fddi Network Interface BlockSecureFast Virtual Networking I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Power Technical SpeciﬁcationsMemory Address Table SizeService SafetyStandards Dimensions WeightPhysical EnvironmentSpeciﬁcations