Cabletron Systems 9A426-02 manual Status of the FNB Receive LED is listed in Table

Page 39

LANVIEW LEDs

The status of the FNB Receive LED is listed in Table 4-4.

Table 4-4. FNB Receive LED

LED Color	State

Green	Link exists, no activity, port is enabled

Yellow (Flashing)	Link exists, activity, port is enabled

Red	No link, port is disabled

Red (Flashing)	Link exists, port is disabled

Off	No link, no activity, port is enabled

The status of the FNB Transmit LED is listed in Table 4-5.

Table 4-5. FNB Transmit LED

LED Color	State

Green (Flashing)	Activity, port is enabled

Yellow (Flashing)	Port is in standby mode

Red	Port is disabled

Red (Flashing)	Fault or error exists

Off	No activity, port is enabled

The status of the ATM Receive LED is listed in Table 4-6.

Table 4-6. ATM Receive LEDs

LED Color	State

Yellow (Flashing)	Activity

Red	Failure

Off	No Activity

4-3

Image 39

Contents SmartSwitch 9A426-02 User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Declaration of Conformity Page Contents CPU Chapter Lanview LEDs SpeciﬁcationsIntroduction Ietf Fddi MIB FeaturesLanview LEDs Getting Help Related ManualsModule’s Physical Layout Unpacking the Module9A426-02 Module’s two major circuit boards User-Accessible Components on the Module’s MotherboardLook-Up Engines Installing an Apim in the 9A426-02 Module Sram SIMMsAPIMs Removing the 9A426-02 Module’s ATM-Port Retaining Plate Unpacking an ApimATM-Port Retaining Plate Removing the ATM-Port Retaining Plate Inserting an Apim into the 9A426-02 ModuleAttaching an Apim to a 9A426-02 Module Attaching the 9A426-02 Module’s ATM-Port Retaining PlateUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module 12. The Reset Switch Reset SwitchOperation Front Panel Backplane LAN Emulation System Management BusesSMB-1 Bus SMB-10 Bus System Diagnostic ControllerDC/DC Converter INB Network Interface BlockFddi Network Interface Block ATM Network Interface BlockSecureFast Virtual Networking I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Address Table Size PowerTechnical Speciﬁcations MemorySafety ServiceStandards Environment DimensionsWeight PhysicalSpeciﬁcations