Cabletron Systems 9A426-02 manual

Page 3

Notice

Notice

Cabletron Systems reserves the right to make changes in speciﬁcations and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright April 1998 by:

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-5005

All Rights Reserved

Printed in the United States of America

Order Number: 9031918-03

LANVIEW is a registered trademark, and SmartSwitch is a trademark of Cabletron Systems, Inc. CompuServe is a registered trademark of CompuServe, Inc.

i960 microprocessor is a registered trademark of Intel Corp.

Ethernet is a trademark of Xerox Corporation.

i

Image 3

Contents SmartSwitch 9A426-02 User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Declaration of Conformity Page Contents CPU Chapter Lanview LEDs SpeciﬁcationsIntroduction Ietf Fddi MIB FeaturesLanview LEDs Getting Help Related ManualsModule’s Physical Layout Unpacking the Module9A426-02 Module’s two major circuit boards User-Accessible Components on the Module’s MotherboardLook-Up Engines Installing an Apim in the 9A426-02 Module Sram SIMMsAPIMs Removing the 9A426-02 Module’s ATM-Port Retaining Plate Unpacking an ApimATM-Port Retaining Plate Removing the ATM-Port Retaining Plate Inserting an Apim into the 9A426-02 ModuleAttaching an Apim to a 9A426-02 Module Attaching the 9A426-02 Module’s ATM-Port Retaining PlateUser-Accessible Components on the Module’s Daughterboard DIP Switch Switch Function Description Removing the Daughterboard from the Motherboard Securing SMB-1 Prom Installing the Module into the SmartSwitch 9000 Chassis Preparing and Installing the 9A426-02 Module 11. Installing the 9A426-02 Module 12. The Reset Switch Reset SwitchOperation Front Panel Backplane LAN Emulation System Management BusesSMB-1 Bus SMB-10 Bus System Diagnostic ControllerDC/DC Converter INB Network Interface BlockFddi Network Interface Block ATM Network Interface BlockSecureFast Virtual Networking I960 Core Lanview LEDs Status of the INB Receive LED is listed in Table Status of the FNB Receive LED is listed in Table Status of the ATM Transmit LED is listed in Table Status of the Apim Link LNK LED is listed in Table Lanview LEDs Address Table Size PowerTechnical Speciﬁcations MemorySafety ServiceStandards Environment DimensionsWeight PhysicalSpeciﬁcations