Extron electronic HSA 822 Packaging for Shipment, Cont’d, Figure B-3 Installing protective strips

Page 26

Packaging for Shipment, Cont’d

4.

Place the enclosure and clamshell rightside-up on a

 

horizontal surface. To protect the finish, place the

 

enclosure on a soft cloth or rubber mat.

5.

Install the rubber strips that protect the flanged edges of

 

the top of the surface enclosure (figure B-3).

Figure B-3 — Installing protective strips

6.

Release (extend) the top panel.

7. Insert the HSA 822 and the clamshell into one of the foam shells (figure B-4). Either open end of the clamshell and the open top panel will fit into the recesses in the foam.

Figure B-4 — Installing the foam shell

8. Insert the opposite end of the HSA 822 and the clamshell into the remaining foam shell (figure B-5). Firmly push the foam shells together as far as they will go to completely suspend the HSA and clamshell. The sides of the clamshell protrude through slots in the foam.

Figure B-5 — HSA suspended in the foam

B-4

HSA 822 Hideaway® Enclosure • Packaging for Shipment

HSA 822 Hideaway® Enclosure • Packaging for Shipment

B-5

Image 26
Contents Hideaway Surface Access Enclosure HSAPrecautions Extron’s WarrantyPage Table of Contents HSA 822 Hideaway Enclosure Table of Contents, cont’dIntroduction Introduction About the HSA 822 Hideaway EnclosureIntroduction, cont’d InstallationFeatures Preparing the Routing Template InstallationInstallation Overview Once the template assembly is positioned properly, secure Other installation surface. Mark the locationPlace the routing template assembly on the table, centered Assembly to the table with C-clamps figureDo not use isopropyl alcohol or other solvents to Installation, cont’dClean the HSA. Strong solvents will ruin some FinishesInstallation, cont’d Cabling and Installing the AAPs An RJ-11 telephone plug can be connected to the RJ-45 jack Installation, cont’d Cabling the EnclosureBottom panel features Installation, cont’d Routing the AAP Cables BezelsMaintenance and Modifications ThreeMaintenance and Modifications Replacing an AAPMaintenance and Modifications, cont’d Replacing the Bezels Removing and Replacing the EnclosureMaintenance and Modifications, cont’d Replacing the Gas Lift With the top panel bracket detached from the lifting Insert the shaft end of the replacement gas lift throughReconnect the interior AC power cables Platform, the bracket will be floppy atop the gas liftAdjusting the height of the top surface Height adjustment locking screw slotsAdjusting the top surface level Reference InformationPart Numbers SpecificationsReference Information GeneralTop Plate Dimensions Template, Replacement Parts, and AccessoriesInterface Accessories Reference Information, cont’d Included PartsPackaging for Shipment Reference Information, cont’dPackaging for Shipment Figure B-1 HSA 822 return kitFigure B-3 Installing protective strips Packaging for Shipment, Cont’dFigure B-6 Placing the HSA in the shipping carton Packaging for Shipment, Cont’d
Related manuals
Manual 23 pages 6.66 Kb