Operation
5The ECONOMY MODE selection screen will appear.
ECONOMY MODE is a UPS setting that enables enhanced efficiency and reduced BTU output by suspending
ACCEPT AND ADVANCE | VIEW ALTERNATE SETTINGS |
| |
To ACCEPT the current value | To VIEW ALTERNATE SETTINGS, | ||
& ADVANCE to the next | press the | SETUP | BUTTON |
configuration screen, press | repeatedly | (under | 1 second |
the ON/SELECT button (less | each). |
|
|
than 1 second). | AVAILABLE VALUES |
| |
|
| ||
OFF (factory), ON
6The AUDIBLE ALARM selection screen will appear.
The AUDIBLE ALARM screen gives the user the ability to permanently enable or disable the UPS’s audible alarm in case of an alarm event. The factory configuration of ON is ideal for most applications. Certain applications may require the alarm to be disabled, in which case the option of OFF can be selected.
ACCEPT AND ADVANCE | VIEW ALTERNATE SETTINGS |
| |
To ACCEPT the current value | To VIEW ALTERNATE SETTINGS, | ||
& ADVANCE to the next | press the | SETUP | BUTTON |
configuration screen, press | repeatedly | (under | 1 second |
the ON/SELECT button (less | each). |
|
|
than 1 second). | AVAILABLE VALUES |
| |
|
| ||
ON (factory), OFF
7The OVERLOAD ALARM selection screen will appear.
OVERLOAD ALARM refers to the point at which the UPS will sound its’ overload alarm. The factory setting of 105% will provide adequate overload warnings for most applications, but alternative values from 5% to the 105% default (in 5% intervals) are available for custom configurations.
ACCEPT AND ADVANCE | VIEW ALTERNATE SETTINGS |
LEAVE UPS SETUP MODE
To leave UPS setup mode,
PRESS and HOLD the SETUP
BUTTON (about 3 seconds).
NOTE - the UPS must be in STANDBY MODE to change the economy mode setting
LEAVE UPS SETUP MODE
To leave UPS setup mode,
PRESS and HOLD the SETUP
BUTTON (about 3 seconds).
LEAVE UPS SETUP MODE
To ACCEPT the current value
&ADVANCE to the next configuration screen, press the ON/SELECT button (less than 1 second).
To VIEW ALTERNATE SETTINGS, press the SETUP BUTTON repeatedly (under 1 second each).
AVAILABLE VALUES
105% (factory), 95%, 85%, 75%, 65%, 55%, 45%, 35%, 25%, 15%, 5%
To leave UPS setup mode, PRESS and HOLD the SETUP BUTTON (about 3 seconds).
23
3/28/2013 1:05:42 PM |