Moxa Technologies MOXA AirWorks, AWK-1100 Configuring TCP/IP-related Settings, Addressing

Page 26

	MOXA AirWorks AWK-1100 User’s Manual		Web Console Configuration

	NOTE	Make sure the file is a valid configuration backup file for AWK-1100.


	TIP	If you want to back up or restore the configuration from a remote location over the Internet,
		adjust the Timeout and Max no. of retries settings of TFTP Server for remote TFTP
		configuration backup/restore to succeed.

Resetting the Configuration to Factory Defaults

Clicking the Reset button resets the device configuration to factory defaults.

WARNING

Think twice before clicking the Reset button. Doing so will cause you to lose all of your current configuration settings.

Configuring TCP/IP-related Settings

Addressing

The IP address of the AP can be set manually (Set Manually) or automatically assigned by a DHCP server on the LAN (Obtain from a DHCP Server). If you are manually setting the IP address, Subnet mask, and Default gateway settings, set them appropriately, so that they comply with your LAN environment. In addition, you can specify the Host name and Domain (DNS suffix) of the AWK-1100.

3-10

Image 26

Contents Moxa AirWorks AWK-1100 User’s Manual First Edition, JulyDisclaimer Copyright NoticeTrademarks Table of Contents Page Introduction Product Specifications Package ChecklistProduct Features OverviewMechanical Page ‰ Confirming the Settings of the AP and Client Computers Getting StartedFirst-Time Installation and Configuration AP Client Select the Operational Mode for AWK-1100AP/Bridge Configure AWK-1100’s Ieee 802.11 settings Review and Apply SettingsConfiguring Ieee 802.11g-related Settings Deploying the Access Point APSetting up Client Computers Checking if the Ieee 802.11g-related Settings Work Confirming the Settings of the AP and Client ComputersConfiguring TCP/IP-related Settings Checking if the TCP/IP-related Settings Work To check if a client computer can assess the InternetPage Web Console Configuration ‰ Viewing StatusMenu Structure Save, Save & Restart, and Cancel Buttons Home and Refresh ButtonsCurrent Dhcp Mappings Associated Wireless ClientsViewing Status System LogGeneral Operations Link Monitor AP Client mode onlySpecifying the Operational Mode STA-APUpgrading Firmware by Http Administrative PasswordManaging the Firmware AP/Bridge AP Client Backing up and Restoring Configuration Settings by Http Upgrading Firmware by TftpChoose Tftp as the Firmware management protocol Backing up and Restoring Configuration Settings by Tftp Addressing Configuring TCP/IP-related SettingsResetting the Configuration to Factory Defaults Static Dhcp Mappings Dhcp Server AP/Bridge modes onlyBasic Link Integrity Configuring Ieee 802.11g-related SettingsCommunication AP Load Balancing Wireless Distribution SystemAssociation Control Sample wireless bridge network topology Security STA Shared Key , and Auto Set the Access control type to inclusive MAC-Address-Based Access ControlSet the Access control type to exclusive Ieee 802.1X/RADIUS AP mode only Click DownloadInternet Ethernet Type Filters Configuring Advanced SettingsPacket Filters IP Protocol FiltersUPnP ManagementTCP/UDP Port Filters System LogSnmp Page Default Settings Snmp read community LAN InterfaceManagement Snmp write communityWireless client computer cannot associate with an AWK-1100 TroubleshootingWireless Settings Problems TCP/IP Settings Problems AP does not respond to ping from the client computerUnknown Problems Moxa AirWorks AWK-1100 User’s Manual TTE Compliance Statement Regulatory StatementFederal Communication Commission Interference Statement Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement Service Information Moxa Internet Services Following services are providedProblem Report Form Moxa Product † AWK-1100-US † AWK-1100-EU Serial NumberProduct Return Procedure