Moxa Technologies MOXA AirWorks Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement

Page 48

MOXA AirWorks AWK-1100 User’s Manual

Regulatory Statement

Safety

This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment.

EU Countries Intended for Use

The ETSI version of this device is intended for home and office use in Austria, Belgium, Denmark, Finland, France (with Frequency channel restrictions), Germany, Greece, Ireland, Italy, Luxembourg, Portugal, Spain, Sweden, The Netherlands, and United Kingdom.

The ETSI version of this device is also authorized for use in EFTA member states Norway and Switzerland.

EU Countries Not Intended for Use

None.

Potential Restrictive Use

France: only channels 10, 11, 12, and 13.

C-2

Image 48

Contents Moxa AirWorks AWK-1100 User’s Manual First Edition, JulyCopyright Notice TrademarksDisclaimer Table of Contents Page Introduction Package Checklist Product FeaturesProduct Specifications OverviewMechanical Page ‰ Confirming the Settings of the AP and Client Computers Getting StartedFirst-Time Installation and Configuration Select the Operational Mode for AWK-1100 AP/BridgeAP Client Configure AWK-1100’s Ieee 802.11 settings Review and Apply SettingsDeploying the Access Point AP Setting up Client ComputersConfiguring Ieee 802.11g-related Settings Confirming the Settings of the AP and Client Computers Configuring TCP/IP-related SettingsChecking if the Ieee 802.11g-related Settings Work Checking if the TCP/IP-related Settings Work To check if a client computer can assess the InternetPage Web Console Configuration ‰ Viewing StatusMenu Structure Save, Save & Restart, and Cancel Buttons Home and Refresh ButtonsAssociated Wireless Clients Viewing StatusCurrent Dhcp Mappings System LogLink Monitor AP Client mode only Specifying the Operational ModeGeneral Operations STA-APAdministrative Password Managing the FirmwareUpgrading Firmware by Http AP/Bridge AP ClientBacking up and Restoring Configuration Settings by Http Upgrading Firmware by TftpChoose Tftp as the Firmware management protocol Backing up and Restoring Configuration Settings by Tftp Configuring TCP/IP-related Settings Resetting the Configuration to Factory DefaultsAddressing Dhcp Server AP/Bridge modes only BasicStatic Dhcp Mappings Configuring Ieee 802.11g-related Settings CommunicationLink Integrity Wireless Distribution System Association ControlAP Load Balancing Sample wireless bridge network topology Security STA Shared Key , and Auto MAC-Address-Based Access Control Set the Access control type to exclusiveSet the Access control type to inclusive Ieee 802.1X/RADIUS AP mode only Click DownloadInternet Configuring Advanced Settings Packet FiltersEthernet Type Filters IP Protocol FiltersManagement TCP/UDP Port FiltersUPnP System LogSnmp Page Default Settings LAN Interface ManagementSnmp read community Snmp write communityTroubleshooting Wireless Settings ProblemsWireless client computer cannot associate with an AWK-1100 TCP/IP Settings Problems AP does not respond to ping from the client computerUnknown Problems Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement Federal Communication Commission Interference StatementTTE Compliance Statement Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement Service Information Moxa Internet Services Following services are providedProblem Report Form Moxa Product † AWK-1100-US † AWK-1100-EU Serial NumberProduct Return Procedure