Network Technologies ASI-IP-GTW Ethernet data port, Ethernet management port, Protocols

Page 81

ASI-IP-GTW User's Manual

8.2 Ethernet data port

Table 16. Ethernet Data Port Specification

Item

Specification

Maximum ASI data rate

680 Mbit/s

 

 

Maximum IP data rate

700 Mbit/s

 

 

Protocols :

 

Link layer:

IEEE Std 802.3-2002

VLAN:

IEEE Std 802.1q

Transport layer:

RFC 760

UDP:

RFC 768

RTP:

RFC 1889, RFC 3550, RFC 2250,

 

Pro-MPEG CoP3, rev.2

FEC:

RFC2733, Pro-MPEG CoP3, rev.2

DVB/MPEG-2:

ISO/IEC 13818-1:2000

 

Table 17. Electrical Ethernet Data Port Specification

 

 

Item

Specification

 

 

Type

IEEE Std 802.3-2002, 10/100/1000Base-T

 

 

Connector type

RJ45

 

 

Safety status (UK)

SELV

 

Table 18. Optional SFP Ethernet Data Port Specification

 

 

Item

Specification

 

 

Type

Gigabit Ethernet, Small Form-Factor Pluggable

 

(SFP) slot to carry copper or optical SFP,

compatible with approved modules conforming to the Small Form-factor Pluggable Transceiver MultiSource agreements (Sept.14, 2000).

8.3 Ethernet management port

Table 19. Ethernet Management Port Specification

Item

Specification

Type

10/100Base-T

 

 

Connector type

RJ45

 

 

Safety status (UK)

SELV

 

 

8.4 Alarm relay and maintenance port specification

Table 20. Alarm Relay and Maintenance Port Specification

Page 81

Image 81
Contents DVB-ASI to IP Gateway This page is intentionally left blank Rev Date SW ver Comment Important noticePage Table of Contents Options 12.1 Introduction Purpose of this ManualWho Should Use this Manual What Equipment is Covered by this Manual Contact InformationSummary of Features Role of the ASI-IP-GTW in a Typical SystemSoftware versions Page Guided Tour Indicator Colour DescriptionUser Interface Front Panel DescriptionHardware Options ConstructionFunctionality Max value Description Software OptionsInstalling the Equipment Installing the EquipmentIntroduction To fix the equipment Equipment accessTo cable the equipment VentilationASI port To connect the equipmentPower AC Power SupplyPower Cable and Protective Earth Protective Earth /Technical Earth UK BSUSA Nema 5-15P Optional DC Power Supply Connecting the Video Gateway to the AC Power SupplyPin placement Specification Signal Connections IntroductionASI ports Ethernet data port DVB ASI inputDVB ASI output Ethernet management port LEDsBefore Powering up Powering Up/DownPowering Up Powering DownChanging the IP address of the unit Operating the EquipmentOverall status Looking at the WEB interfaceSnmp Main tab Sub-tab DescriptionStatus Product type ASI-IP-GTW Device InfoMain Network1.22 SFP AdvancedDevice info page, Network and SFP sub-page Shows the sub-page for time setting used for alarm reports Time settingsSnmp AlarmsSnmp tab Ping tab PingPage Security Shows the sub-page for user security password protectionInput Configuration IP TXMain IP TX Parameters Input StatusIP TX Status IP TX FEC FEC SettingsPage Ethernet Settings Vlan settingsStatic MAC setting Ping page of an IP transmitter Ping SettingsIP RX Output ConfigurationOutput Status IP RX ParametersIP RX Status FEC sub-page of an IP receiver Page Ethernet sub-page of an IP receiver Ping page of an IP receiver Advanced Tab Advanced TabPage Network Data Network Interface StatusTransmitted Network streams Received Network streams Shows the Network page for a unit configured to IP-RX modeSave/Load Saving a ConfigurationSave/Load page when saving configuration Loading a Configuration1PPS/10MHz interface modules OptionsSeparate 10MHz/1PPS module 2 1PPS interfaceShows the layout Operating the 1PPS/10MHz interface moduleLED description for separate 1PPS/10MHz interface module LED descriptionsShows the layout of the RIP-2 screen RIPv2 functionalityPage IP Transmit Mode Equipment DescriptionFunctional Description IP Receive Mode IP Bi-directional ModeManagement Page Alarm Severity level Description Protocol mapping Overview of Video over IPData Flow Block Diagrams Forward Error Correction FECUDP Mode Page Preventive Maintenance and Fault-finding Preventive MaintenanceMaintenance Fault-finding Fault finding PhilosophyPreliminary Checks PSU LED Unlit / Power Supply Problem Fans Not Working / Overheating Alarm LED lit / Alarm conditionStep Action If the result of action is Yes Check Fan RotationProgress Bitrate estimation Alarm Description Error sourceDisposing of this Equipment To return the unitGeneral Appendix a Glossary Page Page Page DVB ASI port Appendix B Technical SpecificationEthernet data port Alarm relay and maintenance port specificationEthernet management port ProtocolsDC Mains input AC Mains InputPhysical Details Environmental Conditions SafetyCompliance1 Electromagnetic Compatibility EMCInterface to public telecommunication system CE MarkingAppendix C References Ex. http//192.168.0.100/upgrade Appendix D Upgrade of FeaturesFeature upgrade Feature upgrade dialogue Appendix E Upgrading Software Upgrade SWSW load progress Appendix F Quality of service Setting Packet priority MplsLayer 3 Routing Layer 2 priority ASI-IP-GTW Configuration