Network Technologies ASI-IP-GTW, DVB-ASI to IP user manual LEDs, Ethernet management port

ASI-IP-GTW User's Manual

	Table 7. Optional SFP Ethernet data port
Item	Specification
Type	Gigabit Ethernet, Small Form-Factor Pluggable
	(SFP) slot to carry copper or optical SFP,
	compatible with approved modules conforming to
	the Small Form-factor Pluggable Transceiver
	MultiSource agreements (Sept.14, 2000).
	Optical interface must comply with safety
	requirements IEC 60825 (Class 1) and 21 CFR
	1040.10 & 1040.11 (Class 1).

Note: Please note that the optional SFP slot always provide Gigabit Ethernet. Other bitrates are not supported by the SFP slot.

Note: Please note that data will not be available simultaneously on the electrical Ethernet port and the SFP slot. Through the user interface the user selects on which port the data should be available.

2.4.4 Ethernet management port

The ASI-IP-GTW is provided with an Ethernet management port for configuration and control. The interface is 100Base-T. Please connect the management port to the appropriate LAN for configuration and control.

Table 8. Ethernet management port

Item	Specification
Safety status	SELV
Type	10/100Base-T
Connector type	RJ45

Two LEDs are associated with the Ethernet management port.

2.5 LEDs

The ASI-IP-GTW is equipped with 4 LEDs at the front. The following table describes the meaning of the front LEDs.

		Table 9. Front panel LEDs
Indicator	Colour	Description
Power	Green	This LED is lit when power is being received by the
		unit.
Alarm	Red	This LED is lit when a failure is detected by the unit.
IP TX	Blue	This LED is lit when the unit is configured to transmit
		data to the IP Network.
IP RX	Yellow	This LED is lit when the unit is configured to receive
		data from the IP Network

The front LEDs are replicated at the rear panel.

Each ASI port has two LEDs associated with it.

Page 23