Quatech DSCLP-300 Jumpers J10-J23 define the options for this card, Right Card Edge Jumpers

Page 11

Jumpers J10-J23 define the options for this card:

SPAD

J2 J3

J4

J5

J10

J11

J12

J13

J14

J15

J16

J17

J18

J19

J20

J21

J22

J23

X8

X4

X2

CTS0_SEL AUX0_SEL0 AUX0_SEL1 RCLK0_SEL TGL0_SEL0 TGL0_SEL1 RXEN0_SEL CTS1_SEL AUX1_SEL0 AUX1_SEL1 RCLK1_SEL TGL1_SEL0 TGL1_SEL1 RXEN1_SEL

Figure 2 - Right Card Edge Jumpers

DSCLP/SSCLP-200/300 User's Manual

11

Image 11

Contents DSCLP/SSCLP-200/300 Warranty Information Iii Standards to which Conformity is Declared Manufacturers NameManufacturers Address Application of Council DirectiveBase Address and Interrupt Level IRQ Hardware ConfigurationHardware Installation Address Map and Special Registers RS-422 or RS-485 Signal Line TerminationHalf-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Full-duplex/Half-duplex Operation Signal ConnectionsRight Card Edge Jumpers Jumpers J10-J23 define the options for this card1 CTS0SEL, CTS1SEL J10 Force High-Speed Uart Clock X2, X4, or X8 J3, 4 Enable Scratchpad Register SPAD, J2Clock Rate and Optional Registers Clock multiplier jumper options Jumper/connector locations Hardware InstallationChannel Address Range Bit Description Enabling the Special RegistersInterrupt Status Register Dlab Bit Spad Jumper Register selected forQuatech Modem Control Register Quatech Modem Control RegisterWrite Read Options RegisterBit Name Description Clock Rate Uart Clock Maximum Data Multiplier Frequency Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page DOS and other operating systems Other Operating SystemsOS/2 QTPCI.EXE QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback TclkHalf-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsCannot communicate with other equipment TroubleshootingComputer will not boot up DSCLP/SSCLP-200/300