Quatech SSCLP-200, SSCLP-300, DSCLP-200, DSCLP-300 user manual QTPCI.EXE Expert Mode display

Page 37

Figure 14 shows the Expert Mode display for the DSCLP-200/300 after the "Q" key has been pressed. The information from the Basic Mode display is presented along with more details such as the Vendor and Device IDs, PCI Class Code, size of memory and I/O regions, etc. Pressing the "N" key will show similar information for all non-Quatech PCI devices in the system, including those devices integrated on the motherboard. In this example, the "Base addr 0" resource is reserved.

For users interested in even more details, PCI BIOS information can be displayed by pressing the "B" key. Pressing the "I" key displays thePCI interrupt routing table.

Figure 14 --- QTPCI.EXE Expert Mode display

DSCLP/SSCLP-200/300 User's Manual

37

Image 37

Contents DSCLP/SSCLP-200/300 Warranty Information Iii Manufacturers Address Manufacturers NameApplication of Council Directive Standards to which Conformity is DeclaredHardware Installation Address Map and Special Registers Hardware ConfigurationRS-422 or RS-485 Signal Line Termination Base Address and Interrupt Level IRQHalf-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Full-duplex/Half-duplex Operation Signal ConnectionsRight Card Edge Jumpers Jumpers J10-J23 define the options for this card1 CTS0SEL, CTS1SEL J10 Clock Rate and Optional Registers Enable Scratchpad Register SPAD, J2Force High-Speed Uart Clock X2, X4, or X8 J3, 4 Clock multiplier jumper options Jumper/connector locations Hardware InstallationChannel Address Range Interrupt Status Register Enabling the Special RegistersDlab Bit Spad Jumper Register selected for Bit DescriptionQuatech Modem Control Register Quatech Modem Control RegisterBit Name Description Options RegisterWrite Read Clock Rate Uart Clock Maximum Data Multiplier Frequency Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page OS/2 Other Operating SystemsDOS and other operating systems QTPCI.EXE QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback TclkHalf-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsComputer will not boot up TroubleshootingCannot communicate with other equipment DSCLP/SSCLP-200/300