Quatech SSCLP-200, SSCLP-300, DSCLP-200, DSCLP-300 user manual PCI Resource Map, Inta#

Page 45

8 PCI Resource Map

Listed below are the PCI resources used by the DSCLP-200/300. Such information may be of use to customers writing their own device drivers or other custom software. A detailed description of the DSCLP-200/300's UARTs is available on the Quatech web site.

(all numbers in hex)

 

 

PCI Vendor ID:

0x135C

Quatech, Inc.

PCI Device ID:

0x01B0

DSCLP-200/300

 

0x01C0

SSCLP-200/300

PCI Class Code

 

 

Base class:

0x07

Simple communications controller

Subclass:

0x02

Multiport serial controller

Interface:

0x00

 

IRQ sourced by:

INTA#

 

Base address 0:

0x80 bytes I/O

Reserved region

Base address 1:

0x10 bytes I/O

Serial ports

 

 

Port 1 at offset 0x00

 

 

Port 2 at offset 0x08

DSCLP/SSCLP-200/300 User's Manual

45

Image 45
Contents DSCLP/SSCLP-200/300 Warranty Information Iii Manufacturers Address Manufacturers NameApplication of Council Directive Standards to which Conformity is DeclaredHardware Installation Address Map and Special Registers Hardware ConfigurationRS-422 or RS-485 Signal Line Termination Base Address and Interrupt Level IRQHalf-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Full-duplex/Half-duplex Operation Signal ConnectionsRight Card Edge Jumpers Jumpers J10-J23 define the options for this card1 CTS0SEL, CTS1SEL J10 Enable Scratchpad Register SPAD, J2 Clock Rate and Optional RegistersForce High-Speed Uart Clock X2, X4, or X8 J3, 4 Clock multiplier jumper options Jumper/connector locations Hardware InstallationChannel Address Range Interrupt Status Register Enabling the Special RegistersDlab Bit Spad Jumper Register selected for Bit DescriptionQuatech Modem Control Register Quatech Modem Control RegisterOptions Register Bit Name DescriptionWrite Read Clock Rate Uart Clock Maximum Data Multiplier Frequency Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page Other Operating Systems OS/2DOS and other operating systems QTPCI.EXE QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback TclkHalf-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsTroubleshooting Computer will not boot upCannot communicate with other equipment DSCLP/SSCLP-200/300