Quatech DSCLP-300, SSCLP-300, SSCLP-200 Hardware Installation, Jumper/connector locations

Page 15

3Hardware Installation

1.Turn off the power of the computer system in which the DSCLP-200/300 is to be installed.

2.Remove the system cover according to the instructions provided by the computer manufacturer.

3.Make any desired optional jumper setting changes.

4.Install the DSCLP-200/300 in any empty PCI expansion slot. The board should be secured by installing the Option Retaining Bracket (ORB) screw.

5.Replace the system cover according to the instructions provided by the computer manufacturer.

6.Attach and secure the cable connectors to the desired equipment.

7.Turn on the power of the computer system.

The output of the DSCLP-200/300 is a 25-pin D-connector. A cable is provided to convert the D-25 into two standard female D-9 connectors. Please see section 7.7 for a pin-out of the D-9 connector. The SSCLP-200/300 has a single D-9 connector.

Figure 6 --- Jumper/connector locations

DSCLP/SSCLP-200/300 User's Manual

15

Image 15

Contents DSCLP/SSCLP-200/300 Warranty Information Iii Standards to which Conformity is Declared Manufacturers NameManufacturers Address Application of Council DirectiveBase Address and Interrupt Level IRQ Hardware ConfigurationHardware Installation Address Map and Special Registers RS-422 or RS-485 Signal Line TerminationHalf-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Full-duplex/Half-duplex Operation Signal ConnectionsRight Card Edge Jumpers Jumpers J10-J23 define the options for this card1 CTS0SEL, CTS1SEL J10 Enable Scratchpad Register SPAD, J2 Clock Rate and Optional RegistersForce High-Speed Uart Clock X2, X4, or X8 J3, 4 Clock multiplier jumper options Jumper/connector locations Hardware InstallationChannel Address Range Bit Description Enabling the Special RegistersInterrupt Status Register Dlab Bit Spad Jumper Register selected forQuatech Modem Control Register Quatech Modem Control RegisterOptions Register Bit Name DescriptionWrite Read Clock Rate Uart Clock Maximum Data Multiplier Frequency Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page Other Operating Systems OS/2DOS and other operating systems QTPCI.EXE QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback TclkHalf-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsTroubleshooting Computer will not boot upCannot communicate with other equipment DSCLP/SSCLP-200/300