Quatech DSCLP-300, SSCLP-300, SSCLP-200, DSCLP-200 user manual Windows

Page 23

5.3Windows 98

1.After inserting a DSCLP-200/300 for the first time, the "Add New Hardware Wizard will appear at start up. Click the "Next" button.

2.Select "Search for the best driver for you device". Click the "Next" button.

3.On the next dialog, select the "CD-ROM DRIVE" check box. Insert the Quatech COM CD (shipped with the device) into the CD-ROM drive. Click the "Next" button.

DSCLP/SSCLP-200/300 User's Manual

23

Image 23

Contents DSCLP/SSCLP-200/300 Warranty Information Iii Standards to which Conformity is Declared Manufacturers NameManufacturers Address Application of Council DirectiveBase Address and Interrupt Level IRQ Hardware ConfigurationHardware Installation Address Map and Special Registers RS-422 or RS-485 Signal Line TerminationHalf-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Full-duplex/Half-duplex Operation Signal ConnectionsRight Card Edge Jumpers Jumpers J10-J23 define the options for this card1 CTS0SEL, CTS1SEL J10 Force High-Speed Uart Clock X2, X4, or X8 J3, 4 Enable Scratchpad Register SPAD, J2Clock Rate and Optional Registers Clock multiplier jumper options Jumper/connector locations Hardware InstallationChannel Address Range Bit Description Enabling the Special RegistersInterrupt Status Register Dlab Bit Spad Jumper Register selected forQuatech Modem Control Register Quatech Modem Control RegisterWrite Read Options RegisterBit Name Description Clock Rate Uart Clock Maximum Data Multiplier Frequency Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page DOS and other operating systems Other Operating SystemsOS/2 QTPCI.EXE QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback TclkHalf-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsCannot communicate with other equipment TroubleshootingComputer will not boot up DSCLP/SSCLP-200/300