Patton electronic Model 3088/I manual Modify the IP address, Connect to the local IP network

3088/I Getting Started Guide 2 • Initial configuration

1.Start a HyperTerminal session on the PC using the settings:

9600 bps, 8 data bits, no parity, 1 stop bit, no flow control

2.Log in to the RocketLink-G NTU using the factory-default login (superuser) and password (superuser):

Login: superuser

Password: *********

Login successful

Modify the IP address

1.Display current IP interface settings for the RocketLink-G Ethernet LAN port.

ip list interfaces <enter>

IP	Interfaces:
ID	Name IP Address	DHCP	Transport
—-———————————————————————

1 ip1 192.168.200.10 disabled <BRIDGE>

——————————————————————————

2.Modify the IP address for the LAN port according to your network requirements.

ip set interface ip1 ipaddress 10.10.4.10 255.255.255.0

Note The above IP address (10.10.4.10/24) is only an example. You must choose an IP address on the same subnet as your PC.

3.Verify the new address is correct and save it in system boot memory.

→ip list interfaces <enter>

→system config save <enter>

Connect to the local IP network

Now you can connect the RocketLink-G NTU to your local IP network and complete the remaining configu- ration from your PC using a standard web browser.

Connect the RocketLink-G NTU’s Ethernet port (green) to the same Ethernet segment as your PC (see figure 5). The front-panel Ethernet Link LED should turn on. If it does not, press the rear-panel MDI-X switch so that the Ethernet Link LED illuminates.

You can check the connection with the ping command. For example shown in figure 5, you would ping 10.10.4.10 from a PC on the IP network.

Configure the IP address 19