Patton electronic Model 3088/I manual Ethernet LEDs, 100M Yellow

Page 35

3088/I Getting Started Guide	5 • Installation & operation

Ethernet LEDs

There are four Ethernet LEDs: Link, 100M, Tx, and Rx.

Link (Yellow)

The Link LED glows solid when it receives a valid signal on the Ethernet port. If it is not ﬂashing, change the position of the MDI-X switch on the rear panel. If the LED still fails to light, your cable may be faulty.

100M (Yellow)

The Link LED glows solid if the 100Mbps Ethernet link has been negotiated. If there is not Ethernet connec- tion, the LED defaults to on to indicate that the Ethernet port is ready to operate in 100Base-TX mode.

Tx (Yellow)

The Link LED ﬂashes upon transmitting data out the Ethernet port.

Rx (Yellow)

The Link LED ﬂashes when receiving data from the Ethernet port.

LED status indicators

35

Image 35

Contents RocketLink-G G.SHDSL NTU Mailsupport@patton.com Summary Table of Contents Table of Contents Installation & operation Factory replacement parts and accessories RS-232 console interface pin assignments List of Figures List of Tables Structure About this guideAudience Impaired functioning PrecautionsGeneral observations Safety when working with electricityGeneral conventions Typographical conventions used in this documentGeneral information Chapter contentsRocketLink-G 3088/I overview FeaturesInitial conﬁguration Introduction Power up the NTUAC power-up DC power-upConnect a PC and log Power-up indicationConﬁgure the IP address Connect to the local IP network Modify the IP addressConnect the G.SHDSL port Log onto the web management interfaceRear view of 3088/I showing DSL RJ-11 jack Shdsl conﬁg and status DSL Parameters DSL conﬁgurationDSL Error Monitor Conﬁguration DSL Error Monitor ConﬁgurationRun-Time Statistics Shdsl StatusLocal Interface Error Counters DSL Line Error CountersClearing the error counters Clearing Error CountersEthernet & WAN PPP Conﬁg and status Ethernet Basic Port Attributes IP conﬁgurationPPP conﬁguration Ethernet port conﬁgurationEthernet performance statistics Ethernet Advanced Port AttributesConﬁgurable Ethernet parameters Installation & operation Operation InstallationPower-up Connecting the twisted-pair interfaceWAN LEDs LED status indicatorsPower Yellow 100M Yellow Ethernet LEDsSystem Management 3088 RocketLink-G Plug ‘n’ PlayConsole Reset for Factory DefaultSaving the conﬁguration Backing up and restoring saved conﬁgurations AuthenticationUpgrading software on the 3088/I System Software UpgradeDiagnostic tools Ping & Traceroute System tools for testingLED status monitor & deﬁnition Contacting Patton for assistance Patton support headquarters in the USA Warranty coverageContact information RMA numbers Out-of-warranty serviceAppendix a Compliance information Radio and TV Interference FCC Part SafetyCompliance FCC Part 68 Acta StatementAuthorized European Representative Industry Canada NoticeCE Declaration of Conformity Appendix B Speciﬁcations Protocol support General characteristicsShdsl characteristics Ethernet10Base-T/100Base-TX interface Serial connectorDiagnostics ManagementEthernet Tx PowerVDC power supply Ethernet 100MShdsl Physical connection & Transmission Line DimensionsLine Interface EnvironmentAppendix C Factory replacement parts and accessories Model # Description Factory replacement parts and accessoriesAppendix D RJ-11 non-shielded DSL port RJ-11 non-shielded DSL port Appendix E RJ-45 shielded 10/100 Ethernet port RJ-45 shielded 10/100 Ethernet port Appendix F RS-232 console interface Pin assignments RS-232 console interface pin assignments RJ-45 non-shielded Connector EIA-561