Patton electronic Model 3088/I Power, Ethernet 100M, Ethernet Tx, Ethernet Rx, VDC power supply

3088/I Getting Started Guide B • Specifications

Ethernet 100M

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

Ethernet Tx

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

Ethernet Rx

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

Power

Ensure that the power cable used with the external power adapter meets all applicable standards for the country in which it is to be installed, and that it is connected to a wall outlet which has earth ground.

WARNING

The Model 3088/I power input is 5 VDC from an external desk top power supply, universal input 100–240 VAC, 50–60 Hz, 0.3 A. The universal input power supply has a male IEC-320 power entry connector. This power supply connects to the Model 3088/I by means of a barrel jack (center pin is +5V) on the rear panel. Many international power cords are available for the universal power supply (Please refer to Appendix C on page 54 for country-specific power cords.

The Model 3088/I powers up as soon as it is plugged into an AC outlet—there is no power switch.

48 VDC power supply

The external DC adaptor shall be a listed limited power source that incorporates a disconnect device and shall be positioned within easy reach of the operator. The interconnecting cables

CAUTION shall be rated for the proper voltage, current, anticipated tem- perature, flammability, and mechanical serviceability

•Input

-Rated voltage: 36–60 VDC

-Rated current: 0.25 A DC

•Output

-Rated voltage: 5 VDC ± 5%, 5W

-Rated current: 1 A DC

-6-inch cable terminated with 2.5 mm barrel plug, center positive

•Isolation: 500 VDC

Power 52