Patton electronic Model 3088/I manual DSL conﬁguration, DSL Parameters

Page 23

3088/I Getting Started Guide	3 • G.SHDSL config and status

DSL conﬁguration

By going to the Conﬁguration hyperlink in the Conﬁguration Menu, you can conﬁgure the DSL link to speciﬁc parameters if the 3088/I is not used in the Plug ‘n’ Play mode. They are listed as follows.

Note After changing the parameters in the DSL Conﬁguration section of the web page, they take immediate effect upon clicking the Conﬁgure button.

Figure 8. DSL Conﬁguration

DSL Parameters

•Circuit ID: The circuit ID communicated to other units via EOC. EOC (embedded operations channel) is an out-of-band channel speciﬁed in the G.991.2 standard for SHDSL. We use standard EOC messages for our remote loopback. The 3088/I also supports proprietary EOC messages that allow a 3096RC to conﬁgure it.

•Intended DSL Data Rate: This selects the desired DSL data rate.

•Actual DSL Data Rate (kbps): The actual current data rate that the DSL link is operating, minus the DSL overhead (8 kbps).

•Annex Type: Either G.991.2 Annex A or Annex B.

•Device Type: The two options are Remote (default) or Central. When conﬁguring two units back-to-back, one must be remote, the other central.

•Line Probe: The line probe may disabled (default) or enabled for rate adaptive applications.

•Action: To initiate the DSL link, select Start and click on the Conﬁgure button. To take the DSL link down, select Deactivate and click on the Conﬁgure button.

DSL configuration

23

Image 23

Contents RocketLink-G G.SHDSL NTU Mailsupport@patton.com Summary Table of Contents Table of Contents Installation & operation Factory replacement parts and accessories RS-232 console interface pin assignments List of Figures List of Tables Structure About this guideAudience Impaired functioning PrecautionsGeneral observations Safety when working with electricityGeneral conventions Typographical conventions used in this documentGeneral information Chapter contentsRocketLink-G 3088/I overview FeaturesInitial conﬁguration Introduction Power up the NTUAC power-up DC power-upConnect a PC and log Power-up indicationConﬁgure the IP address Connect to the local IP network Modify the IP addressConnect the G.SHDSL port Log onto the web management interfaceRear view of 3088/I showing DSL RJ-11 jack Shdsl conﬁg and status DSL Parameters DSL conﬁgurationDSL Error Monitor Conﬁguration DSL Error Monitor ConﬁgurationRun-Time Statistics Shdsl StatusLocal Interface Error Counters DSL Line Error CountersClearing the error counters Clearing Error CountersEthernet & WAN PPP Conﬁg and status Ethernet Basic Port Attributes IP conﬁgurationPPP conﬁguration Ethernet port conﬁgurationEthernet performance statistics Ethernet Advanced Port AttributesConﬁgurable Ethernet parameters Installation & operation Operation InstallationPower-up Connecting the twisted-pair interfaceWAN LEDs LED status indicatorsPower Yellow 100M Yellow Ethernet LEDsSystem Management 3088 RocketLink-G Plug ‘n’ PlayConsole Reset for Factory DefaultSaving the conﬁguration Backing up and restoring saved conﬁgurations AuthenticationUpgrading software on the 3088/I System Software UpgradeDiagnostic tools Ping & Traceroute System tools for testingLED status monitor & deﬁnition Contacting Patton for assistance Patton support headquarters in the USA Warranty coverageContact information RMA numbers Out-of-warranty serviceAppendix a Compliance information Radio and TV Interference FCC Part SafetyCompliance FCC Part 68 Acta StatementAuthorized European Representative Industry Canada NoticeCE Declaration of Conformity Appendix B Speciﬁcations Protocol support General characteristicsShdsl characteristics Ethernet10Base-T/100Base-TX interface Serial connectorDiagnostics ManagementEthernet Tx PowerVDC power supply Ethernet 100MShdsl Physical connection & Transmission Line DimensionsLine Interface EnvironmentAppendix C Factory replacement parts and accessories Model # Description Factory replacement parts and accessoriesAppendix D RJ-11 non-shielded DSL port RJ-11 non-shielded DSL port Appendix E RJ-45 shielded 10/100 Ethernet port RJ-45 shielded 10/100 Ethernet port Appendix F RS-232 console interface Pin assignments RS-232 console interface pin assignments RJ-45 non-shielded Connector EIA-561