Troubleshooting
Under certain conditions, the AGS generates a fault or warning message. These messages appear on the Xanbus System Control Panel (SCP).
Acknowledging messages When a fault or warning message appears, it will remain on the screen until it is acknowledged by pressing Enter on the Xanbus System Control Panel (SCP). This action removes the message from the screen, but does not clear the condition that caused the fault or warning.
Consult Table 6 and Table 7 for recommendations for resolving the fault after it has been acknowledged.
Warnings that are in the form of a Yes/No question can be acknowledged by pressing Enter for Yes and Exit for No.
Clearing faults To clear active AGS faults, highlight Clear Faults on the AGS menu and press Enter.
Multiple faults and warnings If several fault or warning messages occur before they can be acknowledged or cleared, they are displayed together on a fault list or a warning list. These lists contain messages from every
To view a message from a fault list or warning list:
1.On the list, use the arrow buttons to highlight the message to be viewed.
2.Press Enter.
The complete message appears.
To return to the fault list or warning list, press Exit.
To continue to the menu for the device that caused the fault or warning condition by pressing Exit.
Each time you return to the list after viewing a complete message, the viewed message is removed from the list.
If you have left the fault list or warning list, you can view them at any time from the System Settings menu.
To view a fault list or warning list:
1.On the Select Device menu, highlight System and press Enter.
2.On the System Settings menu, highlight View Fault List or View Warning List.
3.Press Enter.
69 |
