Xantrex Technology 809-0915 manual Using Quiet Time, To enable Quiet Time

Operation of the Xanbus AGS

Using Quiet Time

Use the Quiet Time feature to ensure that the AGS will not start the generator during the night or during times that conflict with local noise restrictions.

Using Quiet Time involves three steps.

1."QT En" must be set to [Enabled]. The default setting is [Enabled].

2."QT Begin" must have an appropriate time set for Quiet Time to start on schedule. The default setting for "QT Begin" is [9:00 PM] or 21:00 if using a 24-hour clock.

3."QT End" must have an appropriate time set for Quiet Time to stop on schedule. The default setting for "QT End" is [8:00 AM] or 8:00 on the 24-hour clock.

For more information about Quiet Time settings, see “QT En” on page 40, “QT Begin” on page 41, and “QT End” on page 42.

To enable Quiet Time:

1.On the Auto Gen Start menu, use the arrow buttons to highlight "QT En".

2.Press Enter.

3.Use the arrow buttons to select [Enabled].

4.Press Enter.

To set the beginning of Quiet Time:

1.On the Auto Gen Start menu, use the arrow buttons to highlight "QT Begin", then press Enter.

2.Use the arrow buttons to select the hour, then press Enter.

3.Use the arrow buttons to select the minutes, then press Enter. If the 24-hour clock is being used, go to step 5.

4.Use the arrow buttons to select AM or PM, then press Enter.

5.Press Exit twice to return to the System Home screen.

To set the end of Quiet Time:

FSW System Home Screen

System Status

Battery	20.4A	53.9V
BatLev		E--F
Load		1235W
AC1	1150W	3202V

Menu

Select Device Menu	AGS Menu		Set Quiet Time settings
Select Device	XAGS 00: Setup			XAGS 00: Adv
System Settings	Advanced Settings			QT En	[Enabled]
FSW3012	GenMode	[ManualOff]		QT Begin	[10:00AM]
EMS	Clear Faults Warnings			QT End	[7:00AM]
XAGS	View Device Info			Gen Type	[2]

1.	On the Auto Gen Start menu, use the arrow buttons to highlight "QT
	End", then press Enter.
2.	Use the arrow buttons to select the hour, then press Enter.
3.	Use the arrow buttons to select the minute, then press Enter.
	If the 24-hour clock is being used, go to step 5.
4.	Use the arrow buttons to select AM or PM, then press Enter.

Figure 35 Using the Quiet Time Feature

5. Press Exit twice to return to the System screen.

66 Xanbus Automatic Generator Start (AGS) Owner’s Guide