Patton electronic Model 3088/I Log onto the web management interface, Connect the G.SHDSL port

3088/I Getting Started Guide 2 • Initial configuration

	Line
Ethernet	-X
	MDI
Console
Power

	MDI-X switch
Connect to Ethernet port	Ethernet port

PC

Figure 5. Connecting the RocketLink-G to the local IP network (Model 3088/I shown)

Log onto the web management interface

You will now access the web management graphical user interface (GUI) to configure the RocketLink-G using a standard web browser (such as Netscape Browser, Mozilla Firefox, or Internet Explorer).

1.At your PC, open a web browser and enter the IP address you assigned to the RocketLink-G’s Ethernet LAN port in step 2 of section “Modify the IP address” on page 19. (In this example, 10.10.4.10.)

(see figure 6)

Figure 6. RocketLink-G web management home page

2.Log in to the web management home page using the username superuser and the password superuser.

Connect the G.SHDSL port

3.Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.

4.Plug one end of the cable into the (yellow) RJ-11 socket (labelled Line) on the RocketLink-G NTU. (See figure 7.)

5.Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.

6.Go to G.SHDSL > Configuration to configure the DSL port parameters.

Configure the IP address 20