Patton electronic Model 3088/I manual LED status indicators, Power Yellow, WAN LEDs

Page 34

3088/I Getting Started Guide	5 • Installation & operation

The Model 3088/I powers up as soon as it is plugged into an AC outlet—there is no power switch.

There are no user-serviceable parts in the power supply section of the Model 3088/I. Fuse replacement should only be performed by qualiﬁed service per-

sonnel. Contact Patton Electronics Technical support at (301)975-1007, via WARNING our web site at www.patton.com, or by e-mail at support@patton.com, for

more information.

LED status indicators

There are eight LEDs that provide information on the state of the unit. Figure 19 shows the location of the front panel LEDs. Following ﬁgure 19 is a description of each LED’s function.

Power

Link	Tx	Rx
	Tx

WAN

				-G	NTU
				-G
				RocketLink™
	100	M	Tx	Rx
Link			Tx


Ethernet

Figure 19. Model 3088/I front panel

Power (Yellow)

The Power LED glows solid during normal operation. At startup, during the POST, the LED blinks once every second. If the POST fails, the unit does not enter normal operation, and the LED blinks once every 0.4 seconds.

WAN LEDs

There are three WAN LEDs: Link, Tx, and Rx.

Link (Yellow)

The Link LED glows solid while a DSL link is established. While the DSL link is training the LED ﬂashes.

Tx (Yellow)

The Link LED ﬂashes as transmitted data is sent over the DSL link.

Rx (Yellow)

The Link LED ﬂashes as data is received from the DSL link.

LED status indicators

34

Image 34

Contents RocketLink-G G.SHDSL NTU Mailsupport@patton.com Summary Table of Contents Table of Contents Installation & operation Factory replacement parts and accessories RS-232 console interface pin assignments List of Figures List of Tables Audience About this guideStructure Precautions Impaired functioningSafety when working with electricity General observationsTypographical conventions used in this document General conventionsChapter contents General informationFeatures RocketLink-G 3088/I overviewInitial conﬁguration DC power-up Power up the NTUAC power-up IntroductionConﬁgure the IP address Power-up indicationConnect a PC and log Modify the IP address Connect to the local IP networkLog onto the web management interface Connect the G.SHDSL portRear view of 3088/I showing DSL RJ-11 jack Shdsl conﬁg and status DSL conﬁguration DSL ParametersDSL Error Monitor Conﬁguration DSL Error Monitor ConﬁgurationShdsl Status Run-Time StatisticsDSL Line Error Counters Local Interface Error CountersClearing Error Counters Clearing the error countersEthernet & WAN PPP Conﬁg and status Ethernet port conﬁguration IP conﬁgurationPPP conﬁguration Ethernet Basic Port AttributesEthernet Advanced Port Attributes Ethernet performance statisticsConﬁgurable Ethernet parameters Installation & operation Connecting the twisted-pair interface InstallationPower-up OperationPower Yellow LED status indicatorsWAN LEDs Ethernet LEDs 100M YellowSystem Management RocketLink-G Plug ‘n’ Play 3088Saving the conﬁguration Reset for Factory DefaultConsole Authentication Backing up and restoring saved conﬁgurationsSystem Software Upgrade Upgrading software on the 3088/IDiagnostic tools LED status monitor & deﬁnition System tools for testingPing & Traceroute Contacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information FCC Part 68 Acta Statement SafetyCompliance Radio and TV Interference FCC PartCE Declaration of Conformity Industry Canada NoticeAuthorized European Representative Appendix B Speciﬁcations Ethernet General characteristicsShdsl characteristics Protocol supportManagement Serial connectorDiagnostics 10Base-T/100Base-TX interfaceEthernet 100M PowerVDC power supply Ethernet TxEnvironment DimensionsLine Interface Shdsl Physical connection & Transmission LineAppendix C Factory replacement parts and accessories Factory replacement parts and accessories Model # DescriptionAppendix D RJ-11 non-shielded DSL port RJ-11 non-shielded DSL port Appendix E RJ-45 shielded 10/100 Ethernet port RJ-45 shielded 10/100 Ethernet port Appendix F RS-232 console interface Pin assignments RJ-45 non-shielded Connector EIA-561 RS-232 console interface pin assignments