TP-Link manual Hardware Connection - Internet, TL-PA4010 AV500 Nano Powerline Adapter

Page 13

2.6 Hardware Connection – Internet

TL-PA4010AV500 Nano Powerline Adapter

2.6 Hardware Connection – Internet

This section describes how to connect the Powerline Adapter into your existing ADSL broadband connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline Adapter to your ADSL broadband connection:

1．Connect one end of the provided Ethernet (RJ-45) cable to the Powerline Adapter’s Ethernet port.

2．Connect the other end of the Ethernet (RJ-45) cable to an available Ethernet port of your ADSL broadband Router.

3．Plug the Powerline Adapter into a wall socket next to the computer.

4．Turn on your computer.

5．Check and confirm that the Power LED, Ethernet LED, and Powerline Adapter are ON.

The hardware connection mechanism is shown below:

Powerline LED on the

7

Image 13

Contents Rev 1.0.0 TL-PA4010 AV500 Nano Powerline AdapterCOPYRIGHT & TRADEMARKS FCC STATEMENT Safety InformationCE Mark Warning This product can be used in the following countries Product Description AV500 Nano Powerline Adapter DECLARATION OF CONFORMITYRd, Nanshan, Shenzhen, China EN EN EN 61000-3-22006+A12009+A22009 EN ENPackage Contents CONTENTSChapter 4 Using the Management Utility Appendix A TroubleshootingTL-PA4010 AV500 Nano Powerline Adapter Package Contents Note 1.3 Important Safety Instructions Chapter 1 Introduction1.1 Conventions 1.2 System Requirement If liquid has been spilled on the product 2.2 LED Indicator Chapter 2 Connecting Mechanism2.1 Introduction StatusInterface 2.3 Physical InterfaceDescription 2.5 Hardware Connection - Computer 2.4 Connection Instruction2.6 Hardware Connection - Internet  Note Chapter 3 Installing Management Utility TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter 4.1 Status Chapter 4 Using the Management Utility4.1.1 Set Local Device’s Network Name 4.2 Network Password is unnecessary to enter for renaming 4.2.1 Rename the Remote Device/Enter Password4.2.2 Add Device 4.3 Advanced 4.4 System 4.4.1 Upgrade Firmware 4.4.2 Reset Device To upgrade the devices firmware, follow these instructions Note 4.4.3 Set All Devices’ Network Name5.2 Set Up a Powerline AV Network with the Pair Button Chapter 5 Advanced Feature How to Use the Pair ButtonsCreate a Powerline network using the Pair button： 5.1 Pair Secure with 128 bits-AESLeave an existing Powerline AV Network Join an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged 1. The Power LED does not light up. Ans. Check the following Appendix A Troubleshooting3. The Powerline LED does not light up 2. The Ethernet LED does not light up. Ans. Check the following