TP-Link TL-PA4010 AV500 Nano Powerline Adapter,  If liquid has been spilled on the product

Page 9
If liquid has been spilled on the product

TL-PA4010AV500 Nano Powerline Adapter

8.Plug this product directly into a wall socket (100Vac~240Vac). Do not use an extension cord between this product and the AC power source.

9.When plugging this product into a wall socket, make sure that the electrical socket is not damaged, and that there is no gas leakage.

10.Place the connecting cables properly so that people won’t stumble or walk on it.

11.This product should be operated from the type of power indicated on the marking label. If you are not sure of the type of power available, consult the qualified technician.

12.Unplug this product from the mains and refer the product to qualified service personnel for the following conditions:

If liquid has been spilled on the product

If the product has been exposed to rain or water

13.Unplug this product from the wall socket before cleaning. Use a damp cloth for cleaning. Do not use liquid cleaners or aerosol cleaners.

14.The specification of the fuse is T4AL250V. To avoid damage, please do not change the fuse.

15.The Operating temperature is 0~40(32~104).

16.The Storage temperature is -40~70(-40~158).

3

Image 9
Contents Rev 1.0.0 TL-PA4010 AV500 Nano Powerline AdapterCOPYRIGHT & TRADEMARKS Safety Information FCC STATEMENTCE Mark Warning This product can be used in the following countries Product Description AV500 Nano Powerline Adapter DECLARATION OF CONFORMITYRd, Nanshan, Shenzhen, China EN EN EN 61000-3-22006+A12009+A22009 EN ENPackage Contents CONTENTSChapter 4 Using the Management Utility Appendix A TroubleshootingPackage Contents TL-PA4010 AV500 Nano Powerline Adapter Note 1.3 Important Safety Instructions Chapter 1 Introduction1.1 Conventions 1.2 System Requirement If liquid has been spilled on the product 2.2 LED Indicator Chapter 2 Connecting Mechanism2.1 Introduction Status2.3 Physical Interface InterfaceDescription 2.5 Hardware Connection - Computer 2.4 Connection Instruction2.6 Hardware Connection - Internet  Note Chapter 3 Installing Management Utility TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter 4.1 Status Chapter 4 Using the Management Utility4.1.1 Set Local Device’s Network Name 4.2 Network 4.2.1 Rename the Remote Device/Enter Password Password is unnecessary to enter for renaming4.2.2 Add Device 4.3 Advanced 4.4 System 4.4.1 Upgrade Firmware 4.4.2 Reset Device To upgrade the devices firmware, follow these instructions Note 4.4.3 Set All Devices’ Network Name5.2 Set Up a Powerline AV Network with the Pair Button Chapter 5 Advanced Feature How to Use the Pair ButtonsCreate a Powerline network using the Pair button: 5.1 Pair Secure with 128 bits-AESJoin an existing Powerline AV Network Leave an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged 1. The Power LED does not light up. Ans. Check the following Appendix A Troubleshooting3. The Powerline LED does not light up 2. The Ethernet LED does not light up. Ans. Check the following