TP-Link TL-PA4010 manual Connection Instruction, Hardware Connection - Computer

Page 12
2.4 Connection Instruction

TL-PA4010AV500 Nano Powerline Adapter

which it is associated with and its network name assumes a random value. The Power LED turns off when it disconnects from the Powerline network.

2.For detailed information about the Pair button, please refer to Chapter 5 Advanced Feature: How to Use the Pair Buttons

2.4 Connection Instruction

To ensure the optimum performance of the Powerline Adapter and significantly improve the transmission capacity of the network, we recommend that you comply with the following connection rule:

Plug the Powerline Adapter directly into a wall socket but not the multiple sockets.

2.5 Hardware Connection – Computer

For those computers you wish to be networked by Powerline Adapter, each of the computers must be properly connected with a Powerline Adapter through an Ethernet (RJ-45) cable.

Following are the steps to properly connect the Powerline Adapter to your computer:

1Connect one end of the provided Ethernet (RJ-45) cable to the Powerline Adapter’s Ethernet port.

2Connect the other end of the Ethernet (RJ-45) cable to you computer’s LAN port.

3Plug the Powerline Adapter into a wall socket next to the computer.

4Turn on your computer.

5Check and confirm that the 2.5 Hardware Connection – Computer Power LED and Manual backgroundManual backgroundManual backgroundManual background Ethernet LED on the Powerline Adapter are ON.

The hardware connection mechanism is shown below:

6

Image 12
Contents TL-PA4010 AV500 Nano Powerline Adapter Rev 1.0.0COPYRIGHT & TRADEMARKS Safety Information FCC STATEMENTCE Mark Warning This product can be used in the following countries DECLARATION OF CONFORMITY Product Description AV500 Nano Powerline AdapterRd, Nanshan, Shenzhen, China EN EN EN 61000-3-22006+A12009+A22009 EN ENCONTENTS Package ContentsChapter 4 Using the Management Utility Appendix A TroubleshootingPackage Contents TL-PA4010 AV500 Nano Powerline Adapter Note Chapter 1 Introduction 1.3 Important Safety Instructions1.1 Conventions 1.2 System Requirement If liquid has been spilled on the product Chapter 2 Connecting Mechanism 2.2 LED Indicator2.1 Introduction Status2.3 Physical Interface InterfaceDescription 2.4 Connection Instruction 2.5 Hardware Connection - Computer2.6 Hardware Connection - Internet TL-PA4010 AV500 Nano Powerline Adapter Chapter 3 Installing Management Utility TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter Chapter 4 Using the Management Utility 4.1 Status4.1.1 Set Local Device’s Network Name 4.2 Network 4.2.1 Rename the Remote Device/Enter Password Password is unnecessary to enter for renaming4.2.2 Add Device 4.3 Advanced 4.4 System 4.4.1 Upgrade Firmware To upgrade the devices firmware, follow these instructions 4.4.2 Reset Device Note 4.4.3 Set All Devices’ Network NameChapter 5 Advanced Feature How to Use the Pair Buttons 5.2 Set Up a Powerline AV Network with the Pair ButtonCreate a Powerline network using the Pair button: 5.1 Pair Secure with 128 bits-AESJoin an existing Powerline AV Network Leave an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged Appendix A Troubleshooting 1. The Power LED does not light up. Ans. Check the following3. The Powerline LED does not light up 2. The Ethernet LED does not light up. Ans. Check the following