TP-Link manual Network, TL-PA4010 AV500 Nano Powerline Adapter

Contents Rev 1.0.0 TL-PA4010 AV500 Nano Powerline AdapterCOPYRIGHT & TRADEMARKS Safety Information FCC STATEMENTCE Mark Warning This product can be used in the following countries Product Description AV500 Nano Powerline Adapter DECLARATION OF CONFORMITYRd, Nanshan, Shenzhen, China EN EN EN 61000-3-22006+A12009+A22009 EN ENPackage Contents CONTENTSChapter 4 Using the Management Utility Appendix A TroubleshootingPackage Contents TL-PA4010 AV500 Nano Powerline Adapter Note 1.3 Important Safety Instructions Chapter 1 Introduction1.1 Conventions 1.2 System Requirement If liquid has been spilled on the product 2.2 LED Indicator Chapter 2 Connecting Mechanism2.1 Introduction Status2.3 Physical Interface InterfaceDescription 2.5 Hardware Connection - Computer 2.4 Connection Instruction2.6 Hardware Connection - Internet  Note Chapter 3 Installing Management Utility TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter 4.1 Status Chapter 4 Using the Management Utility4.1.1 Set Local Device’s Network Name 4.2 Network 4.2.1 Rename the Remote Device/Enter Password Password is unnecessary to enter for renaming4.2.2 Add Device 4.3 Advanced 4.4 System 4.4.1 Upgrade Firmware 4.4.2 Reset Device To upgrade the devices firmware, follow these instructions Note 4.4.3 Set All Devices’ Network Name5.2 Set Up a Powerline AV Network with the Pair Button Chapter 5 Advanced Feature How to Use the Pair ButtonsCreate a Powerline network using the Pair button： 5.1 Pair Secure with 128 bits-AESJoin an existing Powerline AV Network Leave an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged 1. The Power LED does not light up. Ans. Check the following Appendix A Troubleshooting3. The Powerline LED does not light up 2. The Ethernet LED does not light up. Ans. Check the following