TP-Link manual Installing Management Utility, TL-PA4010 AV500 Nano Powerline Adapter,  Note

Page 15

Chapter 3 Installing Management Utility

TL-PA4010AV500 Nano Powerline Adapter

Chapter 3 Installing Management Utility

Please verify that no other Powerline Adapter or any Encryption Management Utilities are installed before installing the provided software. If other Powerline Utilities are installed, uninstall them and restart your personal computer before installing this provided software.

Note:

To install Management Utility, please make sure that WinPcap 4.1.2 has been installed in your computer. Otherwise, a window will pop up for you to install WinPcap 4.1.2.

Take the following procedures to properly install the provided Management Utility:

Step 1: Insert the Resource CD into your CD-ROM drive, and then the following Setup Wizard will automatically pop up on your computer’s screen.

Step 2: Select 500Mbps Powerline and click Management Utility, and then the program installation process will carry out and copy all the necessary files to your system.

9

Image 15

Contents Rev 1.0.0 TL-PA4010 AV500 Nano Powerline AdapterCOPYRIGHT & TRADEMARKS Safety Information FCC STATEMENTCE Mark Warning This product can be used in the following countries EN EN EN 61000-3-22006+A12009+A22009 EN EN DECLARATION OF CONFORMITYProduct Description AV500 Nano Powerline Adapter Rd, Nanshan, Shenzhen, ChinaAppendix A Troubleshooting CONTENTSPackage Contents Chapter 4 Using the Management UtilityPackage Contents TL-PA4010 AV500 Nano Powerline Adapter Note 1.2 System Requirement Chapter 1 Introduction1.3 Important Safety Instructions 1.1 Conventions If liquid has been spilled on the product Status Chapter 2 Connecting Mechanism2.2 LED Indicator 2.1 Introduction2.3 Physical Interface InterfaceDescription 2.5 Hardware Connection - Computer 2.4 Connection Instruction2.6 Hardware Connection - Internet  Note Chapter 3 Installing Management Utility TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter TL-PA4010 AV500 Nano Powerline Adapter 4.1 Status Chapter 4 Using the Management Utility4.1.1 Set Local Device’s Network Name 4.2 Network 4.2.1 Rename the Remote Device/Enter Password Password is unnecessary to enter for renaming4.2.2 Add Device 4.3 Advanced 4.4 System 4.4.1 Upgrade Firmware 4.4.3 Set All Devices’ Network Name To upgrade the devices firmware, follow these instructions4.4.2 Reset Device  Note5.1 Pair Secure with 128 bits-AES Chapter 5 Advanced Feature How to Use the Pair Buttons5.2 Set Up a Powerline AV Network with the Pair Button Create a Powerline network using the Pair button：Join an existing Powerline AV Network Leave an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged 2. The Ethernet LED does not light up. Ans. Check the following Appendix A Troubleshooting1. The Power LED does not light up. Ans. Check the following 3. The Powerline LED does not light up