Peavey CS 800x4 owner manual Important Safety Instructions

Page 3

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electrical products, basic cautions should always be followed, including the following:

1. Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11.Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug‚ proceed as follows:

a)The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E‚ the earth symbol‚ colored green or colored green and yellow.

b)The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black.

c)The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red.

12.Only use attachments/accessories provided by the manufacturer.

13.Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a

cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

14. Unplug this apparatus during lightning storms or when unused for long periods of time.

15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

16.Never break off the ground pin. Write for our free booklet “Shock Hazard and Grounding.” Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

17.If this product is to be mounted in an equipment rack, rear support should be provided.

18.Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in suscep- tibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures:

Duration Per Day In Hours

Sound Level dBA, Slow Response

8

90

6

92

4

95

3

97

2

100

1 1⁄2

102

1

105

1⁄2

110

1⁄4 or less

115

According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation.

SAVE THESE INSTRUCTIONS!

3

Image 3
Contents Page Page Important Safety Instructions Bewahren SIE Diese Sicherheitshinweise AUF Gardez CES Instructions Guarde Estas Instrucciones Cooling Requirements Power AmplifierUnpacking MountingConnecting Power Operating PrecautionsConnecting Inputs Connecting OutputsWire Gauge Charts Bridged Mono Operation Operation ModesStereo Operation Parallel OperationInput Attenuators Front Panel Rear Panel Switches & ControlsAC Power Circuit Breakers Mode Select SwitchPWR LED Front Panel IndicatorsProtection Features Speaker Protection RampUp Signal ControlService / Warranty Information Amplifier Maintenance and User ResponsiblityPower Amplifier Power Amplifier Kühlanforderungen EndstufeAuspacken MontageAnschluss der Ausgänge EinleitungSicherheitshinweise für den Betrieb Anschluss der EingängeKabelstärkentabellen Bridged-Mono-Betrieb BetriebsmodiStereobetrieb ParallelbetriebMODE-Wahlschalter Vorderseite Rückseite Schalter und ReglerWechselstrom-Netzschalter/Leistungsschalter EingangsdämpferVorderseite Anzeigen Schutzfunktionen RampUp-Signalregelung LautsprecherschutzEinschalt-/Ausschaltschutz Kundendienst Informationen zur Garantie Wartung Des Verstärkers Und Verantwortung Des NutzersEndstufe Specifications Refroidissement InstallationAmplificateurs de Puissance DéballageAlimentation Electrique Précautions d’UtilisationConnecter les entrées de votre unité Inputs Connecter les entrées de votre unité OutputsLa Charte De Dimensions Des Cables Pont Modes d’OpérationStéréo ParallèlePanneau Avant Panneau Arrière Sélecteurs & Contrôles Panneau Avant Indicators Systèmes de Protection Système RampUp contrôle de montée en puissance Protection des Haut-ParleursRéparation/Informations de Garantie Maintenance et Responsabilité d’UtilisateurAmplificateur de Puissance Power Amplifier Requisitos de enfriamiento Etapa de PotenciaDesembalaje MontajeConectando Salidas IntroducciónPrecauciones de Operación Conectando EntradasTablas de Calibre del Cable Operación en Mono Bridged Modos de OperaciónOperación Estéreo Operación en ParaleloInterruptor de Selección de Modo Panel Frontal Panel Trasero Interruptores & ControlesBreakers del circuito de alimentación AC Atenuadores de EntradaLED PWR Panel Frontal IndicadoresCaracterísticas de Protección Control de Señal RampUp Protección de los altavocesInformación sobre servicio post-venta y garantía Mantenimiento del amplificador y responsabilidad del usuarioEtapa de Potencia Etapa de Potencia Peavey Electronics Corporation Limited Warranty 2005