ClearOne comm AP10 operation manual Hardware Setup, Connect the unit

Page 11

CHAPTER 2: Installation

The AP10 is designed for easy installation and set-up. All connections are made through rear-panel connectors. This section provides instructions on installing the units in the rack and making initial connections, creating a G-Link network, and assigning device ID numbers.

The diagram below illustrates the typical connections that are made when adding an AP10 to an AP800.

Microphones	Touch panel
	Touch panel
	controller

AP800

Inputs

AP10

	G-Link connection
	Receive	Transmit	Telephone set
			(optional)
	Output	Input

Line

Figure 2.1. System diagram

Hardware Setup

Connect the unit

Refer to the rear-panel drawing in Figure 2.2 on the following page. Each connector is numbered for easy identification.

1.Place the unit in the rack and attach it securely. AP10 models are designed for installation in a standard 19-inch equipment rack.

2.Connect your telephone line from the wall jack to the RJ-11C Line jack [F].

3.Plug your telephone set into the RJ-11C Set jack [G].

4.If you are using a custom controller for control and hybrid status, plug it into the DB-25 Remote connector [C].

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 11

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of ContentsOperation AppendicesIntroduction FeaturesClearOne Communications EuMEA GmbH Professional Services GroupSales and Customer Service Technical SupportIntroduction ~ Controls and Connections UnpackingControls and Connections Front viewRear view AP10 rear-panel connectorsTelephone line requirements Before You InstallPower requirements Equipment placementTechnical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware SetupCreating a G-Link network Installation ~ Hardware SetupPhoenix connector Assigning device ID numbers Connecting powerDevice ID DIP switch settings Binary DIP Switch Address PositionTechnical Services Group ~ 1-800-283-5936 USA ~ Receive boost DIP Switch SettingsNoise burst/auto-adapt Call progression/loop Receive AGCAuto-answer Auto-disconnectRinging Receive reductionCalibration Noise burst adaptAuto-adapt Transmit level adjustmentReceive level adjustment To make and disconnect a call Using the AP10To answer a call Found Using the Telco InterfaceCustom control through DB-25 port To muteOther telco options ControllersTechnical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a SpecificationsPin Description Remote connector pinoutAppendix B Pinouts Appendices ~ Appendix B PinoutsConventions Set connector pinoutLine connector pinout Appendix C Serial CommandsConvention Description Command structureExample Command form Device AA AP10 Serial CommandsAppendices ~ Appendix C Serial Commands Command FunctionExample Command form Device HookCommand form Device Hookd Command form Device Mute CH Explanation Command form Device LVL CHReturn values Command form Device NullCommand form Device TE Command form Device Terl Return valuesCommand form Device VER Command form Device TerleCommand form Device UID This Warranty is Void if Appendix D WarrantyAppendices ~ Appendix D Warranty Usoc Jacks This device uses RJ-11C and RJ21X terminal jacks Appendix E ComplianceFCC Part 15 Compliance FCC Part 68 ComplianceAppendices ~ Appendix E Compliance Safety InformationIC Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AECGlossary Index Index