ClearOne comm AP10 operation manual DIP Switch Settings, Noise burst/auto-adapt, Receive boost

Page 15

CHAPTER 3: Configuration

DIP Switch Settings

The AP10 has a variety of operational features configurable through DIP switch settings, including noise burst/auto-adapt, receive AGC control, auto-answer, auto- disconnect, call progression/loop, receive reduction, and hook-flash duration. Default settings (as shipped from the factory) are denoted by an asterisk “*”.

Figure 3.1. AP10 DIP switches

Noise burst/auto-adapt

In some applications, you might want to adapt the hybrid with a white noise burst, rather than allow the hybrid to adapt automatically to line conditions. To enable this feature, set DIP switch 1 to the On position.

DIP Switch	Position	Description
1	On (up)	Burst adapt
1*	Off (down)	Auto-adapt

Receive boost

If incoming caller audio is consistently low, activate the Receive Boost. This will increase receive audio by 6dB. To enable this feature, set DIP switch 2 to the On position.

DIP Switch	Position	Description
2	On (up)	6dB Receive audio boost enabled
2*	Off (down)	6dB Receive audio boost disabled

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 15

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of ContentsOperation AppendicesIntroduction FeaturesClearOne Communications EuMEA GmbH Professional Services GroupSales and Customer Service Technical SupportIntroduction ~ Controls and Connections UnpackingControls and Connections Front viewRear view AP10 rear-panel connectorsTelephone line requirements Before You InstallPower requirements Equipment placementTechnical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware SetupInstallation ~ Hardware Setup Phoenix connectorCreating a G-Link network Assigning device ID numbers Connecting powerDevice ID DIP switch settings Binary DIP Switch Address PositionTechnical Services Group ~ 1-800-283-5936 USA ~ DIP Switch Settings Noise burst/auto-adaptReceive boost Call progression/loop Receive AGCAuto-answer Auto-disconnectRinging Receive reductionCalibration Noise burst adaptTransmit level adjustment Receive level adjustmentAuto-adapt Using the AP10 To answer a callTo make and disconnect a call Found Using the Telco InterfaceCustom control through DB-25 port To muteOther telco options ControllersTechnical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a SpecificationsPin Description Remote connector pinoutAppendix B Pinouts Appendices ~ Appendix B PinoutsConventions Set connector pinoutLine connector pinout Appendix C Serial CommandsCommand structure ExampleConvention Description Command form Device AA AP10 Serial CommandsAppendices ~ Appendix C Serial Commands Command FunctionCommand form Device Hook Command form Device HookdExample Command form Device Mute CH Explanation Command form Device LVL CHReturn values Command form Device NullCommand form Device TE Command form Device Terl Return valuesCommand form Device Terle Command form Device UIDCommand form Device VER This Warranty is Void if Appendix D WarrantyAppendices ~ Appendix D Warranty Usoc Jacks This device uses RJ-11C and RJ21X terminal jacks Appendix E ComplianceFCC Part 15 Compliance FCC Part 68 ComplianceSafety Information IC ComplianceAppendices ~ Appendix E Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AECGlossary Index Index