ClearOne comm AP10 operation manual Using the Telco Interface, Found

Page 20

16	Operation ~ Using the Telco Interface

3.When the conversation is complete, press the Off button [E] to disconnect the call. You can also disconnect using an external controller. If the handset is off hook, audio will be routed to the telephone.

If your call is through the handset only (the red Off LED will be lit), hang up when the conversation is complete.

Using the Telco Interface

To make and disconnect a call

1.Open AP-Ware and select the AP10 unit.

2.Click the AP10 Telco button on the Flow Screen to open the Telco interface.

✍

found

Detailed instructions on creating site files and using AP-Ware can be

in the AP-Ware help file.

Figure 4.2. Telco dialing interface

3.Activate the telephone interface by clicking On or by beginning to dial.

4.When the green light below the On button illuminates, enter the number to be dialed, including any dial-out prefixes.

5.Click Send. If you clicked directly on the number buttons, the call will be completed as you finish dialing—just like using a standard telephone.

6.When you are finished with the call, click Disconnect to end the call.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 20

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Table of Contents IiiAppendices OperationFeatures IntroductionProfessional Services Group Sales and Customer ServiceTechnical Support ClearOne Communications EuMEA GmbHUnpacking Controls and ConnectionsFront view Introduction ~ Controls and ConnectionsAP10 rear-panel connectors Rear viewBefore You Install Power requirementsEquipment placement Telephone line requirementsTechnical Services Group ~ 1-800-283-5936 USA ~ Hardware Setup Connect the unitCreating a G-Link network Installation ~ Hardware SetupPhoenix connector Connecting power Device ID DIP switch settingsBinary DIP Switch Address Position Assigning device ID numbersTechnical Services Group ~ 1-800-283-5936 USA ~ Receive boost DIP Switch SettingsNoise burst/auto-adapt Receive AGC Auto-answerAuto-disconnect Call progression/loopReceive reduction CalibrationNoise burst adapt RingingAuto-adapt Transmit level adjustmentReceive level adjustment To make and disconnect a call Using the AP10To answer a call Using the Telco Interface FoundTo mute Other telco optionsControllers Custom control through DB-25 portTechnical Services Group ~ 1-800-283-5936 USA ~ Appendix a Specifications AppendicesRemote connector pinout Appendix B PinoutsAppendices ~ Appendix B Pinouts Pin DescriptionSet connector pinout Line connector pinoutAppendix C Serial Commands ConventionsConvention Description Command structureExample AP10 Serial Commands Appendices ~ Appendix C Serial CommandsCommand Function Command form Device AAExample Command form Device HookCommand form Device Hookd Command form Device LVL CH Command form Device Mute CH ExplanationCommand form Device Null Command form Device TECommand form Device Terl Return values Return valuesCommand form Device VER Command form Device TerleCommand form Device UID Appendix D Warranty This Warranty is Void ifAppendices ~ Appendix D Warranty Appendix E Compliance FCC Part 15 ComplianceFCC Part 68 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacksAppendices ~ Appendix E Compliance Safety InformationIC Compliance Appendix F Block Diagram Acoustic Echo Cancellation AEC GlossaryGlossary Index Index