ClearOne comm AP10 operation manual Technical Services Group ~ 1-800-283-5936 USA ~

Page 2

ii

© 2002 ClearOne Communications, Inc. All

rights reserved. No part of this document may

be reproduced in any form or by any means

without written permission from ClearOne

Communications, Inc. Printed in the United

States of America. ClearOne Communications

reserves specific privileges. Information in this

document is subject to change without notice.

AP10 Installation and Operation

Manual

ClearOne Part No. 800-150-201

June 2002 (Rev. 2.0)

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 2

Contents AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Table of Contents IiiAppendices OperationFeatures IntroductionTechnical Support Professional Services GroupSales and Customer Service ClearOne Communications EuMEA GmbHFront view UnpackingControls and Connections Introduction ~ Controls and ConnectionsAP10 rear-panel connectors Rear viewEquipment placement Before You InstallPower requirements Telephone line requirementsTechnical Services Group ~ 1-800-283-5936 USA ~ Hardware Setup Connect the unitCreating a G-Link network Installation ~ Hardware SetupPhoenix connector Binary DIP Switch Address Position Connecting powerDevice ID DIP switch settings Assigning device ID numbersTechnical Services Group ~ 1-800-283-5936 USA ~ Receive boost DIP Switch SettingsNoise burst/auto-adapt Auto-disconnect Receive AGCAuto-answer Call progression/loopNoise burst adapt Receive reductionCalibration RingingAuto-adapt Transmit level adjustmentReceive level adjustment To make and disconnect a call Using the AP10To answer a call Using the Telco Interface FoundControllers To muteOther telco options Custom control through DB-25 portTechnical Services Group ~ 1-800-283-5936 USA ~ Appendix a Specifications AppendicesAppendices ~ Appendix B Pinouts Remote connector pinoutAppendix B Pinouts Pin DescriptionAppendix C Serial Commands Set connector pinoutLine connector pinout ConventionsConvention Description Command structureExample Command Function AP10 Serial CommandsAppendices ~ Appendix C Serial Commands Command form Device AAExample Command form Device HookCommand form Device Hookd Command form Device LVL CH Command form Device Mute CH ExplanationCommand form Device Terl Return values Command form Device NullCommand form Device TE Return valuesCommand form Device VER Command form Device TerleCommand form Device UID Appendix D Warranty This Warranty is Void ifAppendices ~ Appendix D Warranty FCC Part 68 Compliance Appendix E ComplianceFCC Part 15 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacksAppendices ~ Appendix E Compliance Safety InformationIC Compliance Appendix F Block Diagram Acoustic Echo Cancellation AEC GlossaryGlossary Index Index